06 Honda Odyssey remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68722
Printed Date: May 04, 2024 at 11:44 AM
Topic: 06 Honda Odyssey remote start
Posted By: northern
Subject: 06 Honda Odyssey remote start
Date Posted: December 19, 2005 at 12:14 PM
Need wiring diagram for remote start. I did a search, all the direct tech's wiring guides have dead links.
Replies:
Posted By: Velocity Motors
Date Posted: December 19, 2005 at 2:49 PM
Links for fine for me. Here's the information:
DIRECTWIRE™ WIRING INFORMATION - HONDA / ODYSSEY / 2006 / Remote Start
[PRINT THIS PAGE]
12volts white (50A) + ignition harness
Starter BLACK/ white + ignition harness
Second Starter N/A
Ignition BLACK / YELLOW + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory BLACK/ red + ignition harness
Second Accessory WHITE/ red + ignition harness
Keysense RED / white - ign harn or MICU, 30 pin plug, pin 2
Notes: The MICU (Multiplex Integrated Control Unit) is part of the driver side fuse/relay box. It has two plugs on the side edge of the fuse/relay box.
Power Lock pink/black - pass kick or MICU, 30 pin plg, pin20
Notes: Meter this wire while pressing the passenger side door lock switch.
The MICU (Multiplex Integrated Control Unit) is part of the driver side fuse/relay box. It has two plugs on the side edge of the fuse/relay box.
Power Unlock green - pass kick or MICU, 30 pin plg, pin 6
Notes: Meter this wire while pressing the passenger side door lock switch.
The MICU (Multiplex Integrated Control Unit) is part of the driver side fuse/relay box. It has two plugs on the side edge of the fuse/relay box.
Lock Motor yellow/black 5wi driver fuse/relay box, 12 pin plug
Unlock Motor YELLOW /GREEN 5wi driver fuse/relay box, 12 pin plug
Parking Lights+ RED / black + dri fuse/relay box, rear 17 pin plug
Parking Lights- RED / black - headlight switch in column cover
Hazards GREEN/ red + hazard switch
Turn Signal(L) RED / blue + dri fuse/relay box, rear 17 pin plug
Turn Signal(R) brown + dri fuse/relay box, rear 17 pin plug
Reverse Light green + dr kick or MICU, 14 pin plug, pin 11
Notes: The MICU (Multiplex Integrated Control Unit) is part of the driver side fuse/relay box. It has two plugs on the side edge of the fuse/relay box.
Door Trigger yellow - interior light switch on dash
Notes: The individual door trigger wires are at the rear of the driver fuse/relay box in the driver kick. The LF door is green in a 16 pin plug, pin 15. The RF door is lt. GREEN/ red in a 14 pin plug, pin 12. The LR door is GREEN/ YELLOW in a 16 pin plug, pin 14. The RR door is GREEN / WHITE in a 14 pin plug, pin 13. Use all four wires and diode isolate each.
Dome Supervision BLACK/ red - interior light switch on dash
Trunk/Hatch Pin GREEN/ black or lt. GREEN/ black - rear junction box, 13 pin plug
Notes: The rear junction box is in the passenger side quarter panel.
Hood Pin yellow/red to GREEN/ black - pin switch under hood
Trunk/Hatch Release WHITE/ black and yellow/blue power tailgate switch on dash
Notes: Use a relay to connect the WHITE/ black and yellow/blue wires to release the power tailgate.
Power Sliding Door see DirectFax document 1085
Notes: Follow the wiring on DirectFax document 1085 using the following wire colors:
driver side open - WHITE/ blue
driver side close - WHITE/ black
driver side common - GREEN / WHITE
passenger side open - pink
passenger side close - RED / white
passenger side common - lt. green
Factory Alarm Arm blue/white to WHITE/ blue - driver door module in door
Notes: Meter this wire while turning the key in the driver door key cylinder.
Factory Alarm Disarm BLACK/ red to white - driver door module in door
Notes: Meter this wire while turning the key in the driver door key cylinder.
Disarm No Unlock see factory alarm disarm
Tachometer NOT yellow/black ac any fuel injector
Wait to start N/A
Brake Wire WHITE/ black + brake pedal switch
Parking Brake GREEN/ orange - parking brake switch
Horn Trigger GREEN/ YELLOW - horn switch
Memory Seat 1 blue - driver kick or power seat ctrl unit
Notes: The power seat control unit is under the driver seat.
Memory Seat 2 blue / YELLOW - driver kick or power seat ctrl unit
Notes: The power seat control unit is under the driver seat.
Memory Seat 3 N/A -
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: northern
Date Posted: December 19, 2005 at 6:28 PM
try posting them again, i think after a few days they go dead. They take me to directed's website, but then it says enter user/password.
Posted By: Velocity Motors
Date Posted: December 19, 2005 at 6:51 PM
&yr=6110&product=Remote%20Start
The link doesn't go dead. It a static link that the information is stored in on their server. Try copying it and pasting this information. I just did it and it worked for me.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: mo12v
Date Posted: December 19, 2005 at 8:57 PM
northern is correct.
DEI has changed their PRINT Links or my computer is also messed up. Velocity Link:
&yr=6110&product=Remote%20Start Correct Link:
https://www.directechs.com/directwire/wire_body.asp?action=select&yr=6110&product=Remote Start ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: gus1
Date Posted: December 20, 2005 at 12:15 AM
And have a good old fashioned aggrivating time getting that tilt handle off so you can get the shroud off....... my least favourite Honda
Gus
-------------
Wherever I go, that is where I end up......
Posted By: thepencil
Date Posted: December 20, 2005 at 9:14 AM
30 minute to take it off and 50 minute to get it back on for the first timer. 
35 minute to take it off and 1 hour to get it back on for the second timer. 
1 hour to take it off and 2 hours to get it back on for those in a hurry. 
Unlike you gus1. It's my favourite!
------------- Be careful whose advice you buy, but be patient with those who supply it. 
Posted By: knauto
Date Posted: January 21, 2006 at 1:13 AM
Hi i'm have some problem with installations remote stater & alarm on Honda odyssey 2006 i 'm using HOLD3 module by pass control all door lock & alarm but only problem that when i starter the car with key then remove it i can not lock the door i have to unlock & lock again then it work ?? does any one know how to fix this problem ? ------------- Ken
Posted By: Chris Luongo
Date Posted: January 21, 2006 at 8:00 PM
If you apply the parking brake pedal hard, there is enough room to get the ignition wires there.
And then you can unsnap the column shroud JUST enough to fish the ring for the bypass module around the key cylinder.
It's still one of my least favorite cars, but that does make it a lot easier.
|