Designtech Autocommand
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68725
Printed Date: May 11, 2025 at 11:08 PM
Topic: Designtech Autocommand
Posted By: bigt_45
Subject: Designtech Autocommand
Date Posted: December 19, 2005 at 12:37 PM
I have a Designtech Autocommand Remote starter installed in a 96 suburban. I am trying to program the unit for the one button transmitter, but it wont go into programming mode. I can wiggle the RCA cable for the antenna and get lucky enough to enter programming mode, but it wont stay long enough for anything. Do I need to buy a new antenna? Where would I get one?
Replies:
Posted By: Velocity Motors
Date Posted: December 19, 2005 at 2:00 PM
Place a slight bend on the center pin and push in the outer prongs to make a tight fit around the male end of the connector.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Powermyster
Date Posted: December 19, 2005 at 5:52 PM
lol neat trick jeff
-------------
Why oh Why didn't i take the blue pill
Darren Power
Posted By: bigt_45
Date Posted: December 20, 2005 at 10:07 AM
Ok, I did that and I think im gettin a good connection, but it still kicks out of programming mode and then wont re-enter. Is there any kind of wiring problem or short that could be causing this?
|