Connecting 556HW to Prestige APS996a

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68776
Printed Date: May 19, 2025 at 1:58 PM

Topic: Connecting 556HW to Prestige APS996a

Posted By: spooken
Subject: Connecting 556HW to Prestige APS996a
Date Posted: December 20, 2005 at 1:40 AM

Hi guys,
My 03 Honda Accord currently has a 556U installed as the bypass module for Prestige APS996a. I want to change to 556H(W) so I can get my key back. I'm a little confused on how to connect the bypass module to the remote starter brain. The brain basically has a "2-pin Transponder Control Output" while the bypass module only shows that I need to connect just 1 cable.

The question is how do I do about doing this? Here are the PDFs to the Prestige APS996a and DEI 556H(W) installation manuals

Prestige APS996A Manual - See page 14 & diagram @ page 25

DEI 556H(W) Manual - See page 2 - 03 Honda Accord

Thanks

Replies:

Posted By: redpeppers
Date Posted: December 20, 2005 at 2:05 AM

the 556u only uses 3 wires ...a red , black and blue......put the red to the red on the 556h and the black and the blue to the blue white....then follow the wire diagram the wire in the rest of the wires.....

-------------
Where theres is a wire there's a way.

Posted By: spooken
Date Posted: December 20, 2005 at 11:13 AM

[QUOTE]the 556u only uses 3 wires ...a red , black and blue......put the red to the red on the 556h and the black and the blue to the blue white....then follow the wire diagram the wire in the rest of the wires.....[/QUOTE]

Just want to confirm, I need to put the black and blue from 556U to just one cable on 556H which is Blue/White?