2004 Sable, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69255
Printed Date: July 12, 2025 at 8:01 PM
Topic: 2004 Sable, remote start
Posted By: mobilecustoms
Subject: 2004 Sable, remote start
Date Posted: December 26, 2005 at 9:47 PM
I am installing a remote start dei 561r in a 2004 sable tomorrow. I have a 556u key bypass and have a question. Blue- status output, black- ground red- 12 volt is this constant or ignition?
Also for a anti grind. How do i wire this up if the 556u is on the status output wire of the remote starter? The anti grind relay also uses this wire?
Replies:
Posted By: KarTuneMan
Date Posted: December 27, 2005 at 1:06 AM
Wire the 12V, to constant...for the bypass. The anti-grind has NOTHING to do with the bypass.
-------------
Posted By: Mike M2
Date Posted: December 27, 2005 at 6:29 AM
An antigrind relay can share the status wire, just tee off....
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: mobilecustoms
Date Posted: December 27, 2005 at 8:30 AM
i am putting one in a 2004 mercury sable ls
black- ground
blue- status output
red?- does this go to ignition or constant 12volts?
Posted By: mobilecustoms
Date Posted: January 03, 2006 at 9:36 PM
i installed a 561r remote start in a 04 sable ls mercury and the doors fall asleep when left alone for a while. I read that you can pulse the door trigger for the driver door, yellow/black while thge unlock wire at the same time, diode isolate. Is this true? Which way does the diode go, the stripe? This is my first time for a diode in a car.
|