00 caviler remote start keyless entry
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69326
Printed Date: July 14, 2025 at 4:20 AM
Topic: 00 caviler remote start keyless entry
Posted By: fastime
Subject: 00 caviler remote start keyless entry
Date Posted: December 27, 2005 at 5:54 PM
Installed a Bulldog 82I on a 2000 caviler w/keyless entry and now the factory keyfobs don't work unless the car is running ... any insite on this would be greatly appreciated , thanks guys
Replies:
Posted By: sparkie
Date Posted: December 27, 2005 at 6:24 PM
If you say that the factory keyless entry system only works with the vehicle running, then your remote starter may be either hooked up incorretly or may be jamming the operating frequency that the keyless works on. Some other manufacturerers have also run into this interference proble. On 2000 and newer Cavaliers and Sunfires with factory alarm certain remote starter manufacturerers found that the two systems used the same transmiiter frequencies and caused problems. They had to come up with different remotes and antennas for these vehicles to eliminate the problem. The problem repeated itself for some 2003 and newer GM full size trucks. You can also try moving the remote starter brain away from the BCM to help reduce interference. The BCM is located above the driver's kick panel. The BCM is the receiver for the factory keyless entry and has a thin black wire about 8 inches long, for an antenna.
-------------
sparky
Posted By: Hornshockey
Date Posted: December 28, 2005 at 2:13 AM
-
-------------
Life moves pretty fast; if you don't stop and look around once in a while; you could miss it.
|