99 Plymouth Neon, remote starter/alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69345
Printed Date: July 18, 2025 at 5:12 AM

Topic: 99 Plymouth Neon, remote starter/alarm

Posted By: seldenr
Subject: 99 Plymouth Neon, remote starter/alarm
Date Posted: December 27, 2005 at 10:38 PM

Ive searched the forums with no luck so far, any help would be greatly appreaciated.

I have a 99 Plymouth Neon Manual Trans. I am trying to finish installing a remote starter/alarm (Scytek RS5000 for manual trans), but I have no idea where this one wire goes. The 6 pin starter harness is hooked up properly, but in the 20 pin main harness, there is a wire that needs to be hooked up to a +12V Ignition Input. Does this need to be hooked up to the same place the 6 pin ignition output wire is connected, or the switch above the clutch? or where?

Thanks!

Replies:

Posted By: 05gt
Date Posted: December 27, 2005 at 10:54 PM

connect it to the ignition wire

Posted By: 05gt
Date Posted: December 27, 2005 at 11:04 PM

if it says connect to 12v (+) ignition output in the manual

connect to ignition wire in the vehicle in this case you can use the wire where you put the ignition wire from the 6 pin main harness

Posted By: seldenr
Date Posted: December 28, 2005 at 11:54 AM

I have a 99 plymouth neon with a manual trans. I am installing a remote starter / alarm. Everything for the alarm is wired and working properly, but i am having a heck of a time getting the hand break input wire hooked up properly.

The switch connected to the hand break when the hand break is engaged it shows 0 volts, when disengaged it shows 12volts. The problem is my alarm requires it to show 12 volts when it is engaged. I think i need a relay, but im not sure what kind to buy, and how to hook it up properly.

Any help would be greatly appreaciated.

Thanks.

Posted By: lukedeez
Date Posted: December 28, 2005 at 5:30 PM

i have the same car except mine is automatic and i was wondering if you guys could post some pics?

Posted By: MHARVEY
Date Posted: December 28, 2005 at 5:33 PM

seldenr wrote:

I have a 99 plymouth neon with a manual trans. I am installing a remote starter / alarm. Everything for the alarm is wired and working properly, but i am having a heck of a time getting the hand break input wire hooked up properly.
The switch connected to the hand break when the hand break is engaged it shows 0 volts, when disengaged it shows 12volts. The problem is my alarm requires it to show 12 volts when it is engaged. I think i need a relay, but im not sure what kind to buy, and how to hook it up properly.
Any help would be greatly appreaciated.
Thanks.

so convert the polarity https://www.the12volt.com/relays/page1.asp