code alarm ca545 wont enter programing
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69618
Printed Date: July 12, 2025 at 10:33 AM
Topic: code alarm ca545 wont enter programing
Posted By: petersen,tim
Subject: code alarm ca545 wont enter programing
Date Posted: December 30, 2005 at 10:14 PM
just installed code alarm ca-545 and ca-425 master module and am trying to get transmiters programed to unit,dirrections say to hold valet switch down for up to ten seconds and system will chirp 3 times when it goes to program mode,wont chirp and goes to valet mode,any ideas?
Replies:
Posted By: petersen,tim
Date Posted: December 30, 2005 at 10:49 PM
i have tryed grounding green neg. door input wire and still un able to enter programing mode.
Posted By: kohara73
Date Posted: December 31, 2005 at 9:10 AM
1. Make sure have have good ground on door trigger wire. 2. Make sure you have door trigger wire grounded BEFORE you turn on ignition. 3. Make sure you don't press valet switch until ignition is on. From what it sounds like, you are are not installing the door trigger. The system needs to see the door open first, before anything else. ------------- Keith
Posted By: petersen,tim
Date Posted: December 31, 2005 at 2:05 PM
got unit to go into programing mode,as it was i needed to hold valet button down longer(through valet mode )to get to programing mode,now everything functions correct,remote start and door entry ect. my only problem left is when i programed tach it learned it but now my check engine light is on,do i need to diode tack wire or ? thanks.
Posted By: kohara73
Date Posted: December 31, 2005 at 3:57 PM
What kind of car?? ------------- Keith
Posted By: petersen,tim
Date Posted: December 31, 2005 at 4:20 PM
Posted By: kohara73
Date Posted: January 01, 2006 at 7:53 AM
Try driving it for a few days. That truck uses OBDII engine management. If there's not a "real" problem, the light will turn off. Unless you have a code reader then you can reset the code and see if it comes back. ------------- Keith
Posted By: MHARVEY
Date Posted: January 01, 2006 at 8:59 AM
check to make sure you have both Ignition wires hooked up
Posted By: petersen,tim
Date Posted: January 01, 2006 at 9:43 AM
Keith your GOOD the next time i used the truck the light was out and hasnt come back on since THANKS for your help and taking the time to respond to me Tim
|