door trigger

about to install an alarm in 2005 chrysler pacifica but the door trigger for both door in the front is on module in door.having problem stringing wires in door any recommendation or an alternate wire any help will be appreciated thx

This is what I have on the Pacifica;

"The driver door trigger is purple at the driver door module in the door. The passenger door trigger is PURPLE / white at the passenger door module in the door. The LR door trigger is PURPLE / gray at the BCM, C2, pin 8. The RR door trigger is purple / YELLOW at the BCM, C3, pin 5. Use all four wires and diode isolate each.

The BCM (Body Control Module) is on the driver side firewall under the dash."

Looks like you'll have to go in the module... OR you might be able to use a transponder bypass module. Some have other ouputs that are useful.

-------------

CHRYSLER, PACIFICA, 2005, Door Trigger The driver door trigger is purple at the driver door module in the door. The passenger door trigger is PURPLE / white at the passenger door module in the door. The LR door trigger is PURPLE / gray at the BCM, C2, pin 8. The RR door trigger is purple / YELLOW at the BCM, C3, pin 5. Use all four wires and diode isolate each. The BCM (Body Control Module) is on the driver side firewall under the dash. close

-------------

I have used the domelight wire in the A pillar, had no falsing at all. I do this on the Caravans too, no problems.

-------------
Mike M2
Tech Manager
CS Dealer Services

Astro's IOM-Chrysler 6 controls door locks, sentry key bypass, arm, disarm factory security, sliding doors and hatch.....AND detects any door opening.

-------------