Print Page | Close Window

Ungo Remote starts?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69731
Printed Date: May 22, 2024 at 12:07 AM


Topic: Ungo Remote starts?

Posted By: bass_head1977
Subject: Ungo Remote starts?
Date Posted: January 01, 2006 at 11:41 AM

I recentlly installed a ungo 131s into a 01' Buick Regal.  This car has a simple VATS system so an easy resistor was all I needed for the bypass.  The system I installed is new to me, I have never used Ungo, but heard good things so I tried it.  Unfortunatelly my friend had another installer lined up that bailed with the instructions.  I wasnt able to even download the proper book but installed it anyway using the wire codes on the back of the brain box.  Heres the problem:  Everything works, locks, trunk, lights, but when I start it it will run 5-10sec.  then quit acting like the factory security or tach sense isnt working, but on its 2nd atempt it starts and runs fine.  My resistor is correct, but is there any tach learning sequence, the volt sence did the same thing, or are there programming I need to do.  Most of the systems I use have a tach learning sequence, I.E. Compustar, designtech, viper, but I have no paperwork!!!  Can any of u experienced installers think back a few years and maybe help me out!!!!  A install book would be great! 

Thanks a lot,

Jeremy,

installer, 12 years




Replies:

Posted By: bass_head1977
Date Posted: January 03, 2006 at 12:16 PM

Hey Clarion guys, little help please, I know there are installers who have seen this, any help is appreciated I am going to troubleshoot this weekend!

Thanks





Posted By: gus1
Date Posted: January 03, 2006 at 1:44 PM
It is a DEI piece, I believe......

Think 130XV....

Gus


-------------
Wherever I go, that is where I end up......




Posted By: Velocity Motors
Date Posted: January 03, 2006 at 9:52 PM
Does it have a 14 pin harness, 3 pin door lock harness and then 6 male spade connectors on the side ??

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: xtremca2003
Date Posted: January 03, 2006 at 10:36 PM
Call 1800-go-clarion. Its been about 4 years since I installed ungo products. Some of the older (non dei) units have a green tach sense wire that needed to wrapped around a spark plug wire 5 times.

Chris





Print Page | Close Window