Window module put in with butt connectors
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=70742
Printed Date: May 17, 2025 at 1:20 PM
Topic: Window module put in with butt connectors
Posted By: mmh1
Subject: Window module put in with butt connectors
Date Posted: January 14, 2006 at 7:57 AM
Hi,
I was just wondering if anyone splices in their window closure modules using Butt crimp connectors.
I thought of using this method as it's quick to crimp on a few connector terminals, also should the module fail it would be a case of disconnecting the module and connecting the wires from the windows switches back up again.
If anyone has any views or advice on this method it would be great. Thanks.
Replies:
Posted By: mmh1
Date Posted: January 14, 2006 at 10:03 AM
That should be male and female bullet connectors.
Posted By: infinkc
Date Posted: January 14, 2006 at 11:04 AM
just make sure you electric tape them up so they stay together, chances that it will fail is slim, and if you use regular connectors or solder, you are only going to lose about 1/4" off the wire max when you cut it out. i think its more likely to fail with the butt/bullet connectors than the module itself
-------------
There are 10 types of people in the world, ones that understand binary and ones that dont.
Posted By: Powermyster
Date Posted: January 14, 2006 at 1:29 PM
i would hard wire it in myself.. half decent' module isn't likely to die on you
-------------
Why oh Why didn't i take the blue pill
Darren Power
|