Valet 562, 2002 Honda CRV
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=70825
Printed Date: May 06, 2025 at 5:37 PM
Topic: Valet 562, 2002 Honda CRV
Posted By: philsan12
Subject: Valet 562, 2002 Honda CRV
Date Posted: January 15, 2006 at 10:24 AM
Honda 2002 CRV
This input comes from factory set to 2 activation pulses.
Where does this connect? - install manual shows switch to ground.
Also does the 2 wire Unlock- and lock-from the module go to the car power lock/unlock w/b, w/g wires or the Lock motor wires.
-------------
phil
Replies:
Posted By: mobilecustoms
Date Posted: January 15, 2006 at 10:58 AM
you could hook the wire to a wire that shows neg pulses with the lock on the factory remote and press the factory remote lock two times and the car will start
Posted By: philsan12
Date Posted: January 22, 2006 at 9:18 PM
Honda CRV 2002
Like to have the remote Start activate the rear defogger.The remote start harness H3/5 supplies (-) 200ma output.It can be used to activate the defog trigger seconds after the remote start.Any idea where a trigger wire is and do I need a relay?I figure it can't be a simple as tapping in to the switch wire or is it?
Thaks
-------------
phil
Posted By: KarTuneMan
Date Posted: January 23, 2006 at 9:36 AM
Yellow/black at the switch harness NEG(-) trigger. Use a relay to be safe!
-------------
Posted By: philsan12
Date Posted: February 04, 2006 at 10:53 PM
Thanks BUT?
I take off the 3 dial control panel. Green switch wire assembly behind. About 25 wires. Taped into the yellow black. If I use a DMM no voltage but if I switch on 12+.
If I've got the right wire and I connect the module via relay does nothing?
??? We talking connector right behind the hvac panel?
-------------
phil
|