car ultra starter 2500
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=70834
Printed Date: July 12, 2025 at 10:44 AM
Topic: car ultra starter 2500
Posted By: celestica
Subject: car ultra starter 2500
Date Posted: January 15, 2006 at 11:50 AM
hi my car remote stater ultra2500was working for 2 years (starter 2 ways with alarm),in the last 3 days,the remote starter did not start the car,it flash 7 times no start...i check the book,it said 7 flashes mean no detect tach signal,i dont have the instruction manual to program it,i dont know how...can someone give me some help.. thank you
Replies:
Posted By: mo12v
Date Posted: January 15, 2006 at 12:21 PM
Check the Connection for TACH before ReProgramming.......It may just be a Bad Connection
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: feenal
Date Posted: January 15, 2006 at 2:37 PM
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (Park Lights will turn on).
3) Start the vehicle, LED’s on the antenna will come on to confirm tach signal is detected**, then after two
to ten seconds the park lights will turn off then flash twice to confirm tach learning.
* The system will flash the park lights seven times if not tach learned and the start button is
pressed. The system must be tach learned before remote starting.
** If the LED’s do not come on during tach learn, a proper tach signal was not detected.
Note: If the park lights do not flash in auto tach learn mode it may be necessary to connect to a different
tach source. For best results connect the tach wire to the coil pack or to a fuel injector wire. If necessary
Posted By: celestica
Date Posted: January 15, 2006 at 3:02 PM
mo12v] wrote:
heck the Connection for TACH before ReProgramming.......It may just be a Bad Connection
Posted By: celestica
Date Posted: January 15, 2006 at 3:05 PM
thank you guys the car remote stater was working for longtime,i did not touch nothing.... i will try,i even cant see the wires,it is cold outside and freezing...
Posted By: customak47
Date Posted: January 18, 2006 at 5:18 PM
This unit may be a tachless unit using voltage sensing to tell unit when to stop cranking. Either way, you need to do a system reset to reprogram tach or tachless setting. to do this, you cycle key on/off/on/off/on ( not crank) and press and release the button on the antenna. if done correctly, the park lites will come on and horn will chirp (if connected). then hold down the antenna button until park lites flash 3 times and horn chirp 3 times. this resets all programmable options to default and readys unit for tach/tachless program. If any more questions, check out www.ultrastarters.com, check dealer locator or call tech support. may have faulty unit ------------- My rifle is my friend...
Posted By: celestica
Date Posted: January 18, 2006 at 5:53 PM
thank you. i took it to the le beau where they installed it,did not work,the remote dont accept tach signal,they have to replace it with a new one... thanks to all
|