2004 Silverado starter interrupt
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=70940
Printed Date: May 15, 2025 at 2:48 AM
Topic: 2004 Silverado starter interrupt
Posted By: xxaana
Subject: 2004 Silverado starter interrupt
Date Posted: January 16, 2006 at 9:04 PM
Attempting to install an Audiovox AX-510 and I am having difficulties finding the correct starter interrupt wire. Does anyone have the correct color scheme and location of the wire(s)?
Replies:
Posted By: fingaz22
Date Posted: January 16, 2006 at 9:13 PM
12volts red (x2) + ignition harness
Starter yellow + ignition harness
Second Starter N/A
Ignition pink + ignition harness
Second Ignition white + ignition harness
Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.
Third Ignition N/A
Accessory orange + ignition harness
Second Accessory brown + ignition harness
Keysense lt. green - ignition harness
Power Lock use 457G or 456G module
Notes: If Directed module 457G or 456G is not available, refer to DirectFax document 1601.
On base model trucks, the 457G or 456G is not necessary. Instead, the lock wire is lt. blue (-), pin B5, and the unlock wire is white (-), pin B10. They are in the lt. blue plug at the BCM.
Power Unlock see power lock
Lock Motor gray 5wi driver door module in door
Unlock Motor tan 5wi driver door module in door
Parking Lights+ brown + driver kick panel
Parking Lights- gray/black - BCM, brown plug, pin B2
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Hazards white - steering column, 5 pin plug
Turn Signal(L) dk. green + steering column, 5 pin plug
Turn Signal(R) lt. green + steering column, 5 pin plug
Reverse Light lt. green + BCM, black plug, pin F
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Door Trigger gray/blk (L), BLACK/ wht (R) - each door module in each door
Notes: On base model trucks the door trigger wires are in the lt. blue plug at the BCM, pins B4 and A5. On 4dr trucks the LR door trigger is lt. blue/black, pin A3, and the RR is lt. GREEN/ black, pin A2. They are in the purple plug at the BCM. Use all wires and diode isolate.
The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Dome Supervision gray/black + BCM, black plug, pin E
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Trunk/Hatch Pin N/A
Hood Pin N/A
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm lt. green - driver door module in door
Disarm No Unlock see factory alarm disarm
Tachometer white ac instrument cluster, pin A5 or PCM
Notes: The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. The tach wire is in the green plug, pin 10.
For tach can also go to any of the ignition coils or injectors and use the wire that is NOT pink, black, or brown.
Wait to start dk. blue - instrument cluster, pin A2 or PCM
Notes: The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. The wait to start wire is in the green plug, pin 36.
Brake Wire white + brake pedal switch
Parking Brake lt. blue - BCM, lt. blue plug, pin A7
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Horn Trigger BLACK / YELLOW to black - steering column
Memory Seat 1 red + driver door module in door
Memory Seat 2 pink + driver door module in door
Memory Seat 3 N/A +
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Passlock II
Part #: 555LW
Alternate Part1 #: 555T
Notes: Not required if using the combo interface module.
The Passlock II wire colors are yellow, black, and RED / white (not used).
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Data Bus
Part #: 456G
Notes: Not required if using the combo interface module.
Interface Module: Category:
Combo Interface Required:
Yes Type:
Data Bus
Part #: 457GW
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
JUST ONE MORE AMP!!!
hu,alpine cva 1005/dva 5205
sound processor,symmetry(first one).
sub amp,power 1000 the terminator.(1992).
subs,spl comp dual 1 ohms.
punch 150hd on a 10" ev.
alotofhighs
Posted By: 05gt
Date Posted: January 16, 2006 at 11:10 PM
do you mean the starter wire in the vehicle or the wire you use off of the alarm brain the starter wire in the vehicle is yellow and the wire you use of the brain is orange
Posted By: xxaana
Date Posted: January 17, 2006 at 12:23 PM
The wire off of the vehicle. But the wire that only has power when the starter is turning....
Posted By: extreme1
Date Posted: January 17, 2006 at 2:58 PM
the vehicle has built in starter kill/anti grind.
no need to install an aftermarket one.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: xxaana
Date Posted: January 17, 2006 at 8:23 PM
Thank You!!!! One more question which wire will flash all the tail lights the only ones I can find flash each light seperatly.
Posted By: extreme1
Date Posted: January 18, 2006 at 4:53 PM
xxaana wrote:
Thank You!!!! One more question which wire will flash all the tail lights the only ones I can find flash each light seperatly.
grey/black (-) at the middle connector at the BCM
------------- Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
|