1996 Chrysler Town & Country lock/unlock
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71009
Printed Date: July 07, 2025 at 4:49 PM
Topic: 1996 Chrysler Town & Country lock/unlock
Posted By: mr bumbles
Subject: 1996 Chrysler Town & Country lock/unlock
Date Posted: January 17, 2006 at 10:04 PM
I know that the lock/unlock wire is a GREEN / WHITE located under the BCM but where?. I cannot find it.
-------------
Mr Bumbles
Replies:
Posted By: redpeppers
Date Posted: January 17, 2006 at 10:31 PM
my info says WHITE/ green located at the bottom of the fuse box (1 of 3 wires) - Use relays and set up for negative trigger. Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output. If you don*t have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock.
-------------
Where theres is a wire there's a way.
Posted By: jacqueslacombe
Date Posted: January 18, 2006 at 2:07 AM
HI There is 2 connectors under the fuse box those connectors goes to the BCM module the right one is easy to removed the second one ise harder the one you need to removed is the second one this is the one to the left side there is 2 wire you can use the WHITE/ grenn or the WHITE/ lightgreen those two are close togeter GOOD LOCK
-------------
cocolaboy
|