Compustar remote start in 01 civic

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71075
Printed Date: May 13, 2025 at 3:57 AM

Topic: Compustar remote start in 01 civic

Posted By: j0hns0n
Subject: Compustar remote start in 01 civic
Date Posted: January 18, 2006 at 9:20 PM

I have recently installed a Compustar 2WSS-AS alarm in my 01 civic. I did not connect the 2nd accessory because i did not know where to connect it. Could that be why the car will not crank when i try to remote start?

Replies:

Posted By: mo12v
Date Posted: January 18, 2006 at 9:44 PM

What did you use for a ByPASS?
Why didn' t you finish the Install prior to Remote Starting?

Constant 12 volts	WHITE	IGNITION SWITCH HARNESS
Ignition 12 volts	BLACK / YELLOW	IGNITION SWITCH HARNESS
Starter	BLACK/ WHITE	BACK OF DRIVER FUSE BOX *

* Installing A Starter Kill Relay At The Ignition Switch Harness Before The Starter Wire Enters The Driver Side Fuse Block May Cause A "Check Engine" Light To Come On. Starter Wire Should Be Accessed After Fuse Block.

Ignition #2	BLACK/ RED	IGNITION SWITCH HARNESS
Ignition #3	N/A
Accessory	WHITE/ RED	IGNITION SWITCH HARNESS

Immobilizer Bypass

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: 05gt
Date Posted: January 18, 2006 at 9:45 PM

You need that wire for the 2nd ignition wire in the vehicle

have you programmed the remote, have you programmed tach, have you gone over everything to make sure it is all hooked up properly

that vehicle requires a bypass for the factory immobilizer, part number is 556H (no key required) or the 556U (extra key required) all parts are from DEI

Posted By: j0hns0n
Date Posted: January 18, 2006 at 10:31 PM

I have yet to install the bypass, but shouldn't the remote start work with the key in the ignition? (just to check if remote start works)

Posted By: j0hns0n
Date Posted: January 18, 2006 at 10:46 PM

We did not have time to finish the install so we just got the alarm working and left the bypass for another day. Im guessing its the status wire not being hooked up yet.