Print Page | Close Window

2004 galant, remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71273
Printed Date: July 16, 2025 at 3:32 PM


Topic: 2004 galant, remote start

Posted By: pbrooks67
Subject: 2004 galant, remote start
Date Posted: January 22, 2006 at 11:29 AM

When the key sense wire has been bypassed the car will only start for one second and then shut down.  If the key is set in the ignition, in the off position the remote start works fine.  Is there any other wire than the blue red that needs to be interfaced?



-------------
pb67



Replies:

Posted By: pbrooks67
Date Posted: January 22, 2006 at 11:38 AM
How do you interface the factory trunk release wiring.  I realize that it is not a simple positive trigger system.  According to the fact sheet the system is 5wi.  What does this mean?

-------------
pb67



Posted By: pbrooks67
Date Posted: January 22, 2006 at 11:44 AM

What needs to be done to interface the remote start with the keysense. I have by passed the blue/red wire and the car will only run for one second. If the key is inserted into the ignition in the off positioin the remote starter works fine. Is there another wire that needs to interfaced  for the unit to work?



-------------
pb67



Posted By: cntrylvr79
Date Posted: January 22, 2006 at 12:27 PM
DO you have a bypass module?  There's a chip in the plastic head of that key.  Depending on the module you get you'll have to place one of the keys to the car in the module for it to transmit the signal from the key to the key cylinder when remote started. 

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer


Print Page | Close Window