Print Page | Close Window

2 wire actuator on 3 wire harness

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72008
Printed Date: May 16, 2024 at 10:57 PM


Topic: 2 wire actuator on 3 wire harness

Posted By: aricanderson
Subject: 2 wire actuator on 3 wire harness
Date Posted: February 01, 2006 at 10:02 PM

I have a 96 accord lx and the driver's rear door lock actuator is bad.  So I was wondering can an aftermarket 2 wire door lock actuator be installed on the existing 3 wire harness from the car.  The 3 wires are lock, unlock, and gnd, while the aftermarket actuator will pull or push depending on the polarity.  Can it be hooked up or should I just bite the bullet and buy another honda door lock actuator.

thanks

aric

aricanderson@hotmail.com




Replies:

Posted By: KarTuneMan
Date Posted: February 02, 2006 at 1:01 PM

I would replace it with a factory unit.....96, theres got to be plenty available in the bone yards (wouldn't ya think?)

Its a pretty simple fix too!



-------------


Print Page | Close Window