Adding turn signal lights to Viper 791xv

Just finished wiring up my 98 nissan 240sx with the Viper 791xv, all is good! I would hovever like to have the lights from the turn signals come on just like the parking lights do. Can someone show me how to connect the vehicles turn signal lights to the alarm so that they can turn on when the following happens: alarm goes off, arm/disarm and remote start.    Thanks in advance for the feedback.

you will need 2 or 3 relays to do this. if you are familiar with 5 wire door locks the relay set up will be similar. you will use 1 relay for each turn signal. i personally would do a relay from the parking light output from the alarm to trigger both the right and left turn signals as well as the parking lights. if you do it this way then you need to have the parking light output trigger the first relay with that wire on 86 and a ground on 85. a fused 12 volt source on 30 and 87 going to the parking lights and the other 2 relays. now that relay will now activate the turn signal relays. from that relay the 87 should go to 86 on each one of other 2 relays and 85 goes to ground. then cut the left parking light wire, the switch side of the wire will go to 87a and the parking light side will go to 30. then given that you have positive parking light which you should you will put a fused 12 volt source to 87 and you are ready. do the same to the right side parking light and you are ready to go. never tried this but logically this is how it should work.

-------------
"I cannot teach anybody anything, I can only make them think."
-Socrates-

you will need 1 relay or 2 6amp 6a1 diodes. and just split the parking light output with either and put it to each side indicators

-------------
Why oh Why didn't i take the blue pill
Darren Power