99 suburban, alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72344
Printed Date: July 21, 2025 at 5:01 PM
Topic: 99 suburban, alarm/remote start
Posted By: englishfroggie
Subject: 99 suburban, alarm/remote start
Date Posted: February 07, 2006 at 4:50 AM
I have installed a commando 40/40 remote start, alarm, remote door locks etc. from Asianwolf
It works great. I then installed roll-up modules which when I lock the car they work great. OK so the remote window roll-up activation is from the Armed output (-). When I remote start the car the windows roll-up about an inch and then the engine starts, the problem is that about 5 seconds later the starter motor re-engages and grinds on the already runnning engine. Any ideas, I undid the windows (armed output from the alarm) and it works fine?? Have I used the wrong activation for the windows? Any ideas why it would affect the car? I know that when the car starts a signal is send through this armed output to the Passlock 2 bypass but that should not cause the starter motor to re-engage would it?
Any help would be great.
Replies:
Posted By: mo12v
Date Posted: February 07, 2006 at 7:59 AM
You may need to put a Relay on the Armed Output wire to supply a stronger Ground to the devices that you have hooked to it.
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
|