injector wires for a tach source?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72422
Printed Date: April 23, 2024 at 3:13 PM

Topic: injector wires for a tach source?

Posted By: attlfrank
Subject: injector wires for a tach source?
Date Posted: February 08, 2006 at 10:36 AM

Hi guys ,been a while

I was wondering if I can use the injector wires for a tach sorce,,I thought I saw on this site a guide,,,,something like that there were two wires to each injector ,one was the same color to each one and one was different and you could use the different colored one as a tach

Jeff from Vilocity motors,,,,,I think you posted something about this

Thank You very much for any help

Replies:

Posted By: mobilecustoms
Date Posted: February 08, 2006 at 10:53 AM

yes you can use the odd color injector wire for tach

you can also go to a coil pack

Posted By: mike swanson
Date Posted: February 08, 2006 at 11:56 AM

The one that changes color. And it will never be the same color as IGN.

Crimestopper techs says you should always use an injector.

Posted By: turbo6
Date Posted: February 08, 2006 at 12:43 PM

What they mean is use the uncommon color wire but always test it with a meter and check with a/c voltage.

Posted By: Powermyster
Date Posted: February 08, 2006 at 7:08 PM

like turbo6 said and i can't stress this enough no matter what colour your told or read on here or anywhere. always verify with a DMM

-------------
Why oh Why didn't i take the blue pill
Darren Power

Posted By: attlfrank
Date Posted: February 11, 2006 at 10:39 AM

As always ,much info and help

once again,Thank You very much guys

Print Page | Close Window