directstart cs600
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72656
Printed Date: July 22, 2025 at 10:48 PM
Topic: directstart cs600
Posted By: slyone69
Subject: directstart cs600
Date Posted: February 11, 2006 at 9:41 PM
Please help...installing a 99 GrandCherokee r/s trilogix directstart cs600 model with their bypasskit.com doorlock interface module with a coil wrap. everything is wired correctly and it will start with the remote if the key is in the cylinder...must be a poor wrap?? doors lock/unlock...starter unit works fine if key in cylinder...if no key it will start, run for a few seconds while the dash indivator shows the key symbol flashing and the car dies, then re-starts and dies...any help would be greatly appreciated!!
-------------
PJK
Replies:
Posted By: ziggyb222
Date Posted: February 12, 2006 at 8:27 AM
That is a Sentry key issue.. You need two keys to program the immobilizer.. When programming the module for the immobilizer bypass, make sure that when the second key is inserted in the switch and turned on that you wait enough time to hear the chime sound, indicating it has accepted the second key and you can move on to programming the module for the third key. I had a similar experience with a 2000 Jeep.. Just follow the instruction right to the letter...
Posted By: slyone69
Date Posted: February 14, 2006 at 8:37 PM
THANKS VERY MUCH...WE FOUND OUR PROBLEM...WE WEREN'T HOLDING THE BYPASS UNIT NEAR THE CYLINDER WHILE PROGRAMMING THE BYPASS. WORKS NOW..THANKS AGAIN!!
-------------
PJK
|