parking lights on a 95 sebring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=7290
Printed Date: July 17, 2025 at 2:18 PM

Topic: parking lights on a 95 sebring

Posted By: ericw
Subject: parking lights on a 95 sebring
Date Posted: December 28, 2002 at 5:40 PM

I'm installing a Audiovox APS-685 in my girlfriends car and I am about done, but when I went to hook up the parking lights wire I tested it with the switch off and the wire showed 12 volts on the DMM. The wireing diagram showed GRN/WHT+for the parking lights. Did I hook up to the wrong wire? I hooked it up to the GRN/WHT wire at the switch and the other wire to ground because there are 2 parking light wires that are hooked up to a common and the other to a normally open contacts of a relay inside the module assusmeing that this should work. What do you think?

Replies:

Posted By: Velocity Motors
Date Posted: December 28, 2002 at 9:19 PM

| PARKING LIGHTS +|---------------GREEN / WHITE-----------------------------in drivers kick
| PARKING LIGHTS -|---------------GREEN / WHITE 22 awg----------------steering column *2

*2 Found in a gray 20-pin connector.

If you are using the (-) trigger wire you will need a relay to reverse polarity.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: cool_chick
Date Posted: December 28, 2002 at 10:14 PM

APS685 have two wires for parking light and both are same color(white) if you using Neg Parking light wire in Car either wire go to Neg or if you using Positive wire in Car it's go to Positive 12 volt . that wire is for parking light polarity select.