06 h3 hummer remote starter problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72934
Printed Date: May 01, 2024 at 2:40 AM
Topic: 06 h3 hummer remote starter problem
Posted By: isus
Subject: 06 h3 hummer remote starter problem
Date Posted: February 16, 2006 at 9:13 AM
evything is good except for its starts, runs for a second and then shuts down. used the dei tech soft digram to wire the realys. out of ideas...
Replies:
Posted By: sparkie
Date Posted: February 16, 2006 at 10:17 AM
Recheck your tach circuit and make sure you have programmed it. Make sure your ground is into the chassis and you have got main power from the thick orange wire in a connector high up in the driver's end of the dash. The ignition wire is WHITE/ green and the accessory wire is WHITE/ red. Recheck the resistance reading from your ignition switch and make sure your resistor is exact.
-------------
sparky
Posted By: isus
Date Posted: February 16, 2006 at 10:40 AM
running tachless... check conections already and resistor value.
Posted By: Chris Luongo
Date Posted: February 16, 2006 at 1:41 PM
What relays? What are you using for a bypass?
Posted By: isus
Date Posted: February 16, 2006 at 1:48 PM
made a by pass... worked but no heat... then tried a bypass from crimestopper, pldata4 same thing... no heat...
Posted By: sparkie
Date Posted: February 16, 2006 at 2:33 PM
Recheck your wiring for the relays. If the vehicle doesn't see the accessory wire drop out during start and the correct resistor value during crank the heater won't work even though the accessory wire has power. There is an intermittent problem in the H3's that won't allow anyone's bypass to work. You must use relays and a resistor.
-------------
sparky
Posted By: Velocity Motors
Date Posted: February 16, 2006 at 2:54 PM
For the PLDATAIV did you make sure that you connected the YELLOW/BLACK wire to the Hummer's ACC wire at the ignition switch ? Also, make sure that the ground out when running wire has a (-) trigger on it when remote started.
Did you get the proper light flashes from the module to let you know that the module successfully learned the Passlock code ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|