Print Page | Close Window

05 Tacoma door trigger problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72994
Printed Date: September 13, 2025 at 5:51 PM


Topic: 05 Tacoma door trigger problems

Posted By: nokia15291
Subject: 05 Tacoma door trigger problems
Date Posted: February 17, 2006 at 5:50 AM

OK  I installed a Crimestopper 2016.  Everything works fine except for when the door trigger is connected.  When connected and the truck has been at rest for about 3 hours it will not remote start...just locks the doors.  I believe it loses the 12v to the line after this time

If the (-) door trigger wire is not attached the truck starts fine after sitting all night, but the alarm goes off after it being started for a few seconds

My question is how would I wire a relay that is grounded when door is open and 12v constant when closed so the door trigger on the 2016 will work properly?  Or can I just simply hook the (+) trigger to a 12v constant and the (-) trigger the door circuit?




Replies:

Posted By: nokia15291
Date Posted: February 17, 2006 at 5:52 AM
P.S.    I have a 5 pin relay that I can use...I would rather just use one than having to use two of them...thanks in advance everyone  :)


Print Page | Close Window