02 buick park avenue, alarm/rs wiring

can i get a directtechs sheet for this?

i have everything but the door triggers. i  used a 456b, but the dome lights are ground tirggered so i am not sure what to do. i figured i would just wire it to the door triggers. thanks in advance

-------------

14 views and no one has any info???

-------------

Door Trigger negative trigger, white at light under dash.


This wire will read the dome light delay. Avoiding the delay involves using the 4 separate negative door trigger wires and diode isolating each. They are as follows: For the left front door use gray/black at the driver door module; For the right front door use BLACK/ white at the passenger door module; For the left rear door use lt. blue/black at the rear door module; For the right rear door use lt. GREEN/ black also located at the rear door module.

door modules are in the doors, I would recommend using the domelight wire to simplify installation

-------------
Life moves pretty fast; if you don't stop and look around once in a while; you could miss it.

The domelight doesn't work during the daytime, so that's not the best choice.

I'm not sure what a 456B is.

---The bypasskit.com GM-DLBP will give you a door-trigger output from all four doors, on its pink/white wire, even without connecting the domelight.

---It might be a little harder to find, but the Audiovox AS-GMDTI gives you a door trigger output right off the car's databus.

It does NOT do doorlocks or Passkey bypass, so it is not terribly expensive, and you can leave your other module in place.

NOTE: Audiovox also makes a product called the
AS-GMDTIL, but that's for Trailblazers.......make sure it's an AS-GMDTI that you get.

thank you you guys

-------------