Print Page | Close Window

Viper 560XV Starting Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73319
Printed Date: October 31, 2024 at 6:41 PM


Topic: Viper 560XV Starting Problem

Posted By: 444powerstroke
Subject: Viper 560XV Starting Problem
Date Posted: February 22, 2006 at 3:13 PM

I did a self install of a Viper 560XV into a '93 Camry. I finally got everything working (i thought) but the remote start quick cranking the vehicle. It tries, the starter tries but it doesn't start. I reset the tach and it starting working again. I drove the vehicle for a few minutes and the remote start quit working right. not. I reset the tach again and it starting working. Is this a common problem or do I have the "wrong" tach wire. I connected to the black wire at the igniter.

Thanks.




Replies:

Posted By: 444powerstroke
Date Posted: February 22, 2006 at 3:43 PM
OK, now the vehicle is cranking it just won't stay running very long. It stops and restarts again, keeps repeating this cycle.




Posted By: kohara73
Date Posted: February 22, 2006 at 4:09 PM

Directechs website says black wire at coil, so it sounds like you are on the right wire.  When you learned tach, was engine speed normal?  If it learned tach at too high of engine speed, it may not realize that the motor is running.



-------------
Keith




Posted By: profuse007
Date Posted: February 22, 2006 at 5:05 PM
use tachless mode, very reliable on these model of cars.



-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).




Posted By: nava94
Date Posted: February 22, 2006 at 9:18 PM
let us know how it went. recheck your connections.




Posted By: 444powerstroke
Date Posted: February 23, 2006 at 5:40 PM
Ok, the default tach setting was off. I moved the jumper to the on position and the remote start works fine. Thanks for the help.





Print Page | Close Window