Print Page | Close Window

Durango R/S Key?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73359
Printed Date: April 29, 2024 at 7:06 PM


Topic: Durango R/S Key?

Posted By: Fastlearner
Subject: Durango R/S Key?
Date Posted: February 23, 2006 at 11:15 AM

I can't remember but for some reason i remember reading that there were problems with Dodge and Chrysler Factory imoboliser units. Anyways I'm having a problem with the key for a 05 durango. If you push the key in all the way you can hear a relay clicking. And the car won't start with the key every time.



Replies:

Posted By: Velocity Motors
Date Posted: February 23, 2006 at 11:16 AM
Did you install a remote starter and if you did what bypass module did you use ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: Fastlearner
Date Posted: February 23, 2006 at 11:20 AM
Installed the avital 4000 for just remote start and used the directed 556u box. Everything works ok with the remote start. Its just with using the key.




Posted By: Velocity Motors
Date Posted: February 23, 2006 at 12:48 PM
I've had problems with Dodge vehicles that did this and to test it out, when the vehicle doesn't start with the key, unplug the 556U completely fromt he vehicle and try to start it again after you unplug it. If it starts, then it's the 556U inducing the signal to the Sentry system. I had this happen on a Jeep Liberty and a PT Cruiser last month. Post your results and I'll post what I did if this is in fact what is happening to your installation.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: mike swanson
Date Posted: February 23, 2006 at 2:52 PM
Thats what i would think the car sees 2 keys at the same time. If you use a relay to activate the BP it helped in my case I think that would work for you.




Posted By: cntrylvr79
Date Posted: February 23, 2006 at 7:39 PM
Have had this problem with the 556u in the past.  What I've done is hook both the black, and the blue wires from the 556u to the status ouput of the r/s.  Has worked everytime.

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer




Posted By: Vyse
Date Posted: February 23, 2006 at 10:03 PM
Try adjusting the antenna on the 556UW. I had an 03 Stratus and a Montero act up on me. They would remote start, but not with the key. Try to move the antenna away from the cylinder and then test with the key and the R/S. Get some duct tape or dum gum and make sure it doesn't move. Worked for me so far.




Posted By: Fastlearner
Date Posted: February 24, 2006 at 3:26 AM
What I did was hook up a diode in the wire that goes to the keysense wire and solved both problems.





Print Page | Close Window