problem with horn chirp
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73445
Printed Date: May 14, 2024 at 11:25 PM
Topic: problem with horn chirp
Posted By: leenred
Subject: problem with horn chirp
Date Posted: February 24, 2006 at 8:10 PM
I INSTALLED A HORNET 564T ALARM AND USED A HODL2 DOOR LOCK INTERFACE. THAT AND THE PHK3 WORK JUST FINE. THE ONLY PROBLEM I HAVE IS THAT WHEN I REMOTE START MY VEHICLE THE HORN CHIRPS. IF I SHUT THE CAR OFF AND THAN RESTART IT THE HORN CHIRP WILL NOT GO OFF. IF THE CAR SITS FOR A WHILE AND THAN I REMOTE START THAN THE HORN WILL CHIRP AGAIN. ALSO IF THE ALARM I DISARMED AND THAN REARMED THE HORN WILL NOT CHIRP WHEN I REMOTE START. I WANT TO KNOW IF THE HODL2 IS THE REASON BEHIND THE CHIRPS BECAUSE THE ALARM IS NOT CONNECTED TO THE HORN. CAN I BYPASS THIS HORN CHIRPING? THE CAR IS A 2005 HONDA ACCORD.
Replies:
Posted By: Chris Luongo
Date Posted: February 24, 2006 at 8:24 PM
Which output from the Hornet is connected to the HODL2's brown ground-when-running wire?
The Hornet should have two outputs..... a blue, and a blue/black........ one is "status", one is "ignition 3".
One of those outputs comes on at the EXACT same time as the remote starter powers up the ignition.....the other one comes on a little bit earlier.
You probably need to switch from whatever wire you're using, to the other one.
|