Print Page | Close Window

aftermarket fusion alarm wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73526
Printed Date: July 16, 2025 at 6:53 AM


Topic: aftermarket fusion alarm wiring

Posted By: karlm
Subject: aftermarket fusion alarm wiring
Date Posted: February 26, 2006 at 9:20 AM

Hi there all. New Zealand calling. I recently stripped out my old car ( a 1986 mazda 4 door) fitted with a Fusion alarm model RX-104E-1. The alarm handled door locking and unlocking, had a LED in dash, a microwave sensor with a seperate microwave on/off switch a remote horn speaker and the rest was cabled into the loom. I would like to fit it to my new car but unfortunately have no scematic or wiring diagram. Some detail is on the alarm pcb itself but any help anyone here might be able to provide would be gratefully recieved. Regards Karlm




Replies:

Posted By: karlm
Date Posted: February 26, 2006 at 9:30 AM
ps i should have added that the alarm is about 4 years old..its hard to know. It was in the car when I bought it. It may be that the answer may be to purchase a new alarm but Id like to at least try to get this one going. karlm


Print Page | Close Window