Print Page | Close Window

Compustar CM3000 on 05 Scion TC

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73625
Printed Date: May 15, 2024 at 3:37 PM


Topic: Compustar CM3000 on 05 Scion TC

Posted By: etsnet
Subject: Compustar CM3000 on 05 Scion TC
Date Posted: February 27, 2006 at 8:19 PM

I need help getting the remote start hooked up right. My car is a manual 05 Scion tC below is the wire info for my car and links to the install manuals in pdf format. PLEASE can anyone tell me what connects to what for the remote start. We got the alarm part working. Here's what we connected and didn't for the remote start.

These all tie in to the ignition harness in the car
Brain ---------------------to--------------------Car

Red and RED / white (both are 12volt constant)---------------- Red (12 volts)

GREEN / WHITE (power to parking light)------------------------ Brown (parking light)

White (output to accessory)--------------------------------- Gray (accessory)

Violet (output to starter kill)--------------------------------- Green (second starter) (I think this one above is wrong)

Yellow (12v output sarter)------------------------------------ Black (starter)

GREEN/ red (12v output to ignition)----------------------------- Blue (ignition)

Black (ground)------------------------------------------------ Grounded

There is also a blue wire connected to the brain on connector one with the above stuff that we didn't hook up cuz not sure where it goes. I think this is the one that goes to the clutch but did see something about second starter.

On the second connector on the brain we didn't connect these...

GREEN / WHITE/ (-250mA light output) not connected (not sure if needed or where it goes)

Black (-250mA Status output) not connected (not sure if needed or where it goes)

Green (-250mA 2nd ignition output) not connected (not sure if needed or where it goes)

WHITE/ black (-250mA 2nd accessory output) not connected (not sure if needed or where it goes)

RED / black (-250mA 2nd starter output) not connected (not sure if needed or where it goes)

Here's the manual links:
Compustar Manual 1
Compustar Manual 2

Here's the car wire info:

12volts red (30A), white (25A)+ ignition harness
Starter black + ignition harness
Second Starter green + ignition harness
Ignition blue + ignition harness
Second Ignition yellow + ignition harness
Third Ignition N/A
Accessory gray + ignition harness
Second Accessory N/A
Keysense black - ignition harness
Power Lock green to blue - driver kick, 20 pin plug, pin 15
Power Unlock purple to pink (double pulse) - driver kick, 20 pin plug, pin 14
Lock Motor blue to brown 5wi driver kick, gray 7 pin plug, pin 6
Unlock Motor pink to blue 5wi driver kick, gray 7 pin plug, pin 5
Parking Lights+ brown + top of fuse box, 30 pin plug, pin 29
Parking Lights- brown - headlight switch
Hazards orange - hazard light switch
Turn Signal(L) yellow + top of fuse box, 30 pin plug, pin 27
Turn Signal(R) green + top of fuse box, 30 pin plug, pin 28
Reverse Light pink + top of fuse box, 14 pin plug, pin 2
Door Trigger orange (D), blue (P) - top of fuse box
Dome Supervision blue - L side of fusebox, 6 pin plug, pin 2
Trunk/Hatch Pin purple - top of fuse box, 30 pin plug, pin 7
Hood Pin N/A
Trunk/Hatch Release orange - driver kick, gry 12 pin plug, pin 12
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock use key sense wire
Tachometer black ac data link conn. under dash, pin 9
Wait to start N/A
Brake Wire blue + brake pedal switch
Parking Brake black - parking brake switch
Horn Trigger white - horn switch
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A


THANKS!






Print Page | Close Window