Print Page | Close Window

Toad A850T, Peugeot 306

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73781
Printed Date: July 31, 2025 at 7:48 PM


Topic: Toad A850T, Peugeot 306

Posted By: homehome16
Subject: Toad A850T, Peugeot 306
Date Posted: March 02, 2006 at 11:52 AM

Hi,

I have nearly finished instaling my Toad A850T in to my Peugeot 306. I however have a few problems with the inhbit wire. At the moment I have had to just ground the wire so set the alarm, the problem with this is that it can be armed and disarmed via the reomte and with a key. I just cant work out how to connect it up.. I have tried connecting it to the idicators but when i do that it will not arm. I have also tried adding a relay so that if the idicators are activated (as when the remote is pressed) it activates the realy switch and i have the inhbit wire go to ground, still can not arm. Any ideas on how this needs to be set up.

Also one other issues I am having is that when you program the alarm the led is either suppose to be on or off, for the switch that you are changing. this does not happen. I do however get either 1 beep or 2 beeps..

Any help would be appreciated.

Thanks



Replies:

Posted By: stu_m_75
Date Posted: March 02, 2006 at 5:19 PM
Hi there,
that sounds as if it could be a dodgy alarm module.



Posted By: huruhus
Date Posted: April 06, 2006 at 5:38 PM

hopefully i`m not too late replying, when connecting the inhibit wire you need to use a diode and a resistor.

put the diode inline the cable and the band(white ring mark) facing the alarm, and at any point between the diode and the alarm ground the cable with a 1k resistor.

so when u lock or unlock the inhibit wire will pickup the pulse from the indicator.


Print Page | Close Window