Compustar 2wss-as + DEI Prox Sensor
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73879
Printed Date: May 16, 2024 at 7:46 AM
Topic: Compustar 2wss-as + DEI Prox Sensor
Posted By: 05gt
Subject: Compustar 2wss-as + DEI Prox Sensor
Date Posted: March 03, 2006 at 10:39 PM
I will be putting these two together at work tomorrow, and I am wondering how it can be done Can someone please tell me how to wire this combination up Thanks In advance, Mike
Replies:
Posted By: Ravendarat
Date Posted: March 03, 2006 at 10:49 PM
Check to see if the compustar has a positive multiplex input. If it does than hook up the blue and green wires from the DEI sensor to the multi plex wire then hook up red to 12v and black to ground on the sensor as well and you are good to go.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: 05gt
Date Posted: March 03, 2006 at 10:54 PM
I understand what you said, but is there maybe another way of saying (positive multiplex input) Thanks
Posted By: Ravendarat
Date Posted: March 04, 2006 at 12:29 AM
What it is is a wire that will trigger a warn away chirp with a short signal, say less than .8seconds and then trigger full alarm if its pulsed with a signal longer than .8 seconds. Thats multiplex in this sense. I would think that there is something on there. If not you could check and see if there are seperate triggers, one for warn away and one for full alarm. It might also be called progressive trigger, although those are usually used to refer to door triggers where when pulsed with a signal it will do warn away chirps for 3-5 seconds then full alarm. That way it gives you a warning to disarm the alarm before it goes into full shhh disturbing mode.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: KarTuneMan
Date Posted: March 04, 2006 at 1:46 PM
looking at the install manual...the cn-7 pin 3 is a posative first shock input, they also list a cn-8 "optional sensor" I'll bet thats it! sorry Im no help what soever, Im new to compustar.... Ill keep reading  -------------
|