Print Page | Close Window

Viper 791xv starts on its own!

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74012
Printed Date: May 14, 2024 at 9:20 PM


Topic: Viper 791xv starts on its own!

Posted By: rcantu71
Subject: Viper 791xv starts on its own!
Date Posted: March 06, 2006 at 12:14 AM

hey all, I thought it was my imagination but I just watched my transmitter beep and start the truck. I was 3 ft from the transmitter so I know it was me. My neighbor told me my parking lights were flashing 1 night so it had to be running at that time.

any thoughts?




Replies:

Posted By: KPierson
Date Posted: March 06, 2006 at 12:23 AM

Check the fuse holder at the battery.  Vipers are notorious for starting when applying power to them, and they are alos prone to corroded fuse holders that cause intermittent power problems.

Good luck!



-------------
Kevin Pierson




Posted By: aviator
Date Posted: March 06, 2006 at 12:39 AM

Wow... that is really strange Rcantu....... so this has only happened twice to your knowledge? 

Hope some of the experts can chime in on this one.... tommorrow, a 791XV goes in my Bronco. 



-------------
Kevin
1995 Ford Bronco XLT

When all else fails... try reading the instructions that came with it!!!




Posted By: cntrylvr79
Date Posted: March 06, 2006 at 12:39 AM
Also might want to make sure it's not getting set into the timer mode where it'll start every three hours.  When you hit the remote start button do the parking lights flash twice or 4 times.  If they flash 4 times then it's activating the timer mode.

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer




Posted By: rcantu71
Date Posted: March 06, 2006 at 12:54 AM

it does flash 4 times!  now how can i turn this mofo off :)

cntrylvr79 wrote:

Also might want to make sure it's not getting set into the timer mode where it'll start every three hours.  When you hit the remote start button do the parking lights flash twice or 4 times.  If they flash 4 times then it's activating the timer mode.





Posted By: rallysport
Date Posted: March 06, 2006 at 2:18 AM

i believe it is like this: to enter or turn off timer mode hit lock and unlock at teh same time

to normally start it the car just hit the * twice its something similiar to that ive came accross this issure before



-------------




Posted By: Ravendarat
Date Posted: March 06, 2006 at 9:17 AM
Do you have your owners manual, because its listed in there. Other wise I can check one out when I get to work today.

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer




Posted By: cntrylvr79
Date Posted: March 06, 2006 at 11:36 AM
If you are hitting the lock and unlock buttons at the same time to r/s the truck stop.  Should be just hitting the star button twice to start the car.  If hitting the star button twice is still causing the parking lights to flash four times then something got screwy with the way the remote is programmed.  To reset the transmitter, open the door turn the ignition on push the valet button 11 times.  the push and hold it once more. the led should flash 11 times and the sirenshould also chirp 11 times.  While still holding the valet button down push the lock button on the transmitter.  The siren should chirp once.  Now all transmitters have been delelted from the alarm.  turn the ignition off.  So now you just have to reprogram the transmitter  to the alarm.  Turn the ignition back on push the valet button once.  Then push and hold the button.  The siren will chirp once and led will flash once.  While holding the valet button push the lock button on the transmitter once.  The siren should chirp.  If you have more than one remote for the alarm push the lock button on each of the other remotes now too.  The siren should chirp after each lock button is pressed.  Once you've done that with all the remotes, just turn the ignition off and make sure each transmitter works.  All should be good then.

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer




Posted By: rcantu71
Date Posted: March 06, 2006 at 11:54 AM
thanks guys for the assistance. I got it now. 




Posted By: jonchos
Date Posted: March 07, 2006 at 10:20 AM
Whats the problem with turning the car with the lock and unlock buttons? thats how my remote is set up. I do not use the star button for anything. My alarm is a clifford matrix rsIII.




Posted By: kgerry
Date Posted: March 07, 2006 at 4:27 PM
thats how the old RS3 started... the replacement RSX3.5 starts by pressing the star (snowflake) button TWICE (programmable from 1 to 3 presses)..... as mentioned pressing lock & unlock together on the new units activates timer mode and it will start automatically every three hours to a maximum of 6 times.....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979





Print Page | Close Window