2006 sprinter/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74041
Printed Date: April 26, 2024 at 2:21 PM
Topic: 2006 sprinter/remote start
Posted By: Nate_Dogg
Subject: 2006 sprinter/remote start
Date Posted: March 06, 2006 at 6:32 PM
I'm installing a BWZ1 (black Widow)
The only thing I cannot make it seem to do is start.
I've got a good tach signal,ignition 1,2,starter,acc.etc..
I'm using the key in the ignition to test, but it will
not pick-up the chip in the key. The key sense goes to a ground at start, engine will crank and then die.
Any iders
------------- Chrysler Tech.
Clarion dealer
Black Widow,Ungo alarms.
General electrical
Replies:
Posted By: xscash
Date Posted: March 11, 2006 at 6:02 PM
i dont know if this will help, but here is the wire diag KEY | T-HARNESS | IMMOBILIZER | N/A | N/A | CHRYSLER'S SENTRY ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), Requires 791 Bypass Module and Extra Ignition Key |
PART | COLOR | LOCATION | DIAGRAM | 12 VOLT CONSTANT | RED (+) | IGNITION SWITCH HARNESS | | STARTER | BLACK / YELLOW (+) | IGNITION SWITCH HARNESS | | STARTER 2 | N/A | | | IGNITION 1 | BLACK (+) | IGNITION SWITCH HARNESS | | IGNITION 2 | BLACK/ RED (+) | IGNITION SWITCH HARNESS | | IGNITION 3 | N/A | | | ACCESSORY /HEATER BLOWER 1 | GRAY/DARK GREEN (+) | IGNITION SWITCH HARNESS | | ACCESSORY /HEATER BLOWER 2 | N/A | | | KEYSENSE | N/A | | | PARKING LIGHTS ( - ) | N/A | | | PARKING LIGHTS ( + ) | GRAY/BLACK (+) and GRAY/RED (+) Use both, See NOTE *1 | @ FUSEBOX, BLACK 15 Pin plug, Pins 4 and 6 | 6617_SPRINTER_DUAL PARKING LIGHT DIAGRAM.pdf | POWER LOCK | WHITE/ YELLOW (TYPE B) See NOTE *2 | @ SWITCH on DASH or CTM, PINK Plug, Pin 7, See NOTE *3 | | POWER UNLOCK | WHITE/ YELLOW (TYPE B) See NOTE *2 | @ SWITCH on DASH or CTM, PINK Plug Pin 7, See NOTE *3 | | LOCK MOTOR WIRE | N/A | | | DOOR TRIGGER | BROWN / WHITE (-) | IN DRIVERS DOOR HARNESS | | DOMELIGHT SUPERVISION | USE DOOR TRIGGER | | | TRUNK RELEASE | N/A | | | SLIDING POWER DOOR | N/A | | | HORN | BLACK / YELLOW (-) | @ STEERING COLUMN HARNESS | | TACH | DARK GREEN/ YELLOW | @ DATA LINK CONNECTOR, Pin 3, See NOTE *4 | | WAIT TO START LIGHT | N/A | | | BRAKE | BLACK/ RED (+) | @ SWITCH ABOVE BRAKE PEDAL, See NOTE *5 | | FACTORY ALARM DISARM | BLACK (-) | IN DRIVERS KICK PANEL | | ANTI-THEFT | CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM | TRANSPONDER @ IGNITION SWITCH TUMBLER | |
NOTES | NOTE *1 the PARKING LIGHTS are a 2-Wire System and will require 2 extra Relays part #775, to connect, See DIAGRAM
NOTE *2 a (-)Negative pulse on this wire will alternate between LOCK and UNLOCK. Use DIODES on the LOCK and UNLOCK outputs from the unit if the unit you are using does not have on board Door Lock Relays and wire in as a TYPE B tie both wires to this wire in the vehicle.
NOTE *3 the CTM (Central Timmer Module) is located under the drivers seat.
NOTE *4 the DATA LINK Connector is under the DRIVERS SIDE of DASH.
NOTE *5 the BRAKE LIGHT will only test with ignition on |
|