Print Page | Close Window

DEI 629R LED Wiring, 2002 VW Golf IV

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74201
Printed Date: May 10, 2025 at 12:28 AM


Topic: DEI 629R LED Wiring, 2002 VW Golf IV

Posted By: hatter
Subject: DEI 629R LED Wiring, 2002 VW Golf IV
Date Posted: March 09, 2006 at 2:56 PM

Hi,

I need some help installing a DEI 629 Remote Scanning LED module on a VW Golf MkIV (2002).

Does anyone know where I can tap into a (-) when armed output? Looking at the following
wiring schematic i'm guessing I could tap the black wire into the Hood Pin BROWN / Red wire.
Would this be suitable?

See below for a copy of the wiring instructions.

Thanks in advance

Hatter

posted_image




Replies:

Posted By: xscash
Date Posted: March 09, 2006 at 3:18 PM

i would just set the ground to a ign wire using a diode. this will act as a groung when ever the car is off.

xs




Posted By: Twelvoltz
Date Posted: March 09, 2006 at 3:18 PM
If you use the hood pin wire, the LED will only light when the hood is open.

If you look at that diagram, it shows a wire which activates the starter-kill relay. This wire provides, a -12V when the alarm is armed, this is the wire you want to use.



Posted By: hatter
Date Posted: March 09, 2006 at 3:27 PM

Thanks for the fast replies, i'm a complete 12v novice!   posted_image

I'll give it a go this weekend if it ever stops raining!


Print Page | Close Window