coudnt i just tape off where all the central locking is plug and just work i just confused with the NO NC AnD COM STUFF
ITS a 1999 HRV 2 door all wheel drive ok ill have a look at on how to install relays thanks mate
focas] wrote:
C COM NO For power and NC COM NO for earth could anyone help how i can work out which wires go where thanks heaps
like does a NC wire go to one with 12 when the doors are looked thanks for you time
Regards
Pete
Looks like you got a unit with build in relays. No relays will be require to make the keyless entry to work.
The wire colour maybe different in your vehicle, so test them out first before you make your connection.
| POWER LOCK|GREEN / WHITE |- |driver door harness |
| POWER UNLOCK|GREEN/ orange |- |driver door harness
LOCK
COM = make your connection to Ground.
NC = No connection needed
NO = make your connection to the Power Lock GREEN / WHITE wire of your vehicle.
UNLOCK
COM = make your connection to Ground.
NC = No connection needed
NO = Make your connection to the Power Unlock GREEN/ orange wire of your vehicle.
-------------
Be careful whose advice you buy, but be patient with those who supply it.

hi guys ,
this is probably sorted out by now but i actually do the hrv slightly different and fairly handy too (i think)
the locking can actually be got negative pulse a the cdl box above the pedals,you have two ways of doing this either open the box uop and solder in the points or you can just push them into the blank spaces,its being a little while since i done one but its defo there not sure of exact pin location.i think there is only a few blank spaces so double check.but it makes life very easy.
dave.