Python 440HP, 98 Corolla
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74451
Printed Date: May 07, 2025 at 9:46 PM
Topic: Python 440HP, 98 Corolla
Posted By: rsantos97
Subject: Python 440HP, 98 Corolla
Date Posted: March 14, 2006 at 1:40 AM
I am going to install a Python 440HP system into a 98 Corolla and I wanted to know if I am supposed to connect the Second Unlock Output Wire (BLUE) from the alarm to the Door Trigger Wire (RED / White)?
Thanks
Replies:
Posted By: Twelvoltz
Date Posted: March 14, 2006 at 6:50 AM
If you look at page 6 of your manual it explains the purpose of the blue wire. The wire is used for 2-step door unlocking, in other words it is used to unlock the passenger doors after the drivers door (like most of the factory keyfobs now do). This is NOT a mandatory connection.
Posted By: rsantos97
Date Posted: March 15, 2006 at 12:14 AM
I did read it and I know what it is for, but I don't know which wire it goes connected to because it does not say it in the manual.
Posted By: kobevsjordan
Date Posted: March 15, 2006 at 3:59 AM
Hi, Cut this wire short and tape it up or pull the wire from the harness. You do not need it!!!!!! Hope this helps. ------------- A
Posted By: Twelvoltz
Date Posted: March 15, 2006 at 7:11 AM
OK, then you would use the primary unlock wire to drive a relay to just unlock the drivers door(directly to the actuator in the drivers door), and use the second unlock output to the unlock wire in the vehicle.
Posted By: rsantos97
Date Posted: March 17, 2006 at 12:46 PM
Thanks fellas
|