Uninstalled Viper 791, car won’t start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74923
Printed Date: May 14, 2024 at 5:44 AM
Topic: Uninstalled Viper 791, car won’t start
Posted By: jones100001
Subject: Uninstalled Viper 791, car won’t start
Date Posted: March 22, 2006 at 4:35 PM
I disconnected everything and removed alarm from my car. Can won't crank now. It won't even catch. Any suggestions on what I should check for?
Replies:
Posted By: masterk
Date Posted: March 22, 2006 at 4:45 PM
your starter circuit is open if alarm had starter kill installed when you removed alarm you must reconnect starter wires should have went to starter kill relay ------------- 8d
crawford7827@bellsouth.net
Posted By: kgerry
Date Posted: March 22, 2006 at 4:47 PM
thick violet and green wires from the viper primary harness need to be resoldered together....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: jones100001
Date Posted: March 22, 2006 at 8:47 PM
you suggesting I just reconnect the starter wires?
Posted By: dstang24
Date Posted: March 22, 2006 at 10:26 PM
That's exactly what they're saying. The wires were cut when the alarm was originally installed. Dstang24 ------------- Team Edge Audio
Posted By: jones100001
Date Posted: March 22, 2006 at 10:52 PM
I didn't have access to a soldering gun to solder the starter wires together so I made a jumper cable but still no luck. Maybe something to do w/ factory alarm?
Posted By: Ravendarat
Date Posted: March 22, 2006 at 11:18 PM
What kinda vehicle is this and did you originally install the alarm?
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: jones100001
Date Posted: March 23, 2006 at 12:43 AM
2001 Nissan Maxima and I did the install
Posted By: kgerry
Date Posted: March 23, 2006 at 8:36 AM
plug in the XCRS relay pack... does the car start now? then you need to leave it connected or else resolder the starter wire which was spliced in order to facilitate the starter kill option during the original install.....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: masterk
Date Posted: March 23, 2006 at 8:48 AM
the vechicle has 2 starter wires the main and cold start the main should be BLACK/ red BLACK/ white the 2nd is BLACK/ blue stripe if the starter does not engage at all the problem is with main starter wire if it turns but does not start i would check 2nd starter wire make sure main starter wire has been reconnected after you remove alarm
-------------
8d
crawford7827@bellsouth.net
|