Print Page | Close Window

shock sensor problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=7557
Printed Date: July 20, 2025 at 10:37 AM


Topic: shock sensor problems

Posted By: donkason
Subject: shock sensor problems
Date Posted: January 02, 2003 at 4:57 PM

I have a crimestopper cs-2006fm1 alarm/remote start I am installing in my car.  I mounted the brain behind the glovebox of my 97 camaro and wanted to run the shock sensor to the steering column.  I cut the harness between the alarm unit and the sensor and extended it with some wire I had so I could reach.  For the first few minutes it worked fine and then it quit.  I reattached the harness the way it was and still no response.  Is this the alarm being junk or did I harm it by extending it.  Thanks for your time

Mike




Replies:

Posted By: Velocity Motors
Date Posted: January 02, 2003 at 11:35 PM
You might have a delay in the impact circuitry. Make sure that you are allowing enough time after arming for the system to engage.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window