2005 denali, alarm/remote start

 2005 denali need remote start / alarm info  also would like info for window rollup will be installing aps596 with dei 457g databuss interface module also any tips that might be  helpful

here you go....and there is a bypass that  will also do windows thru the databus...im not sure of which one it is

2005 GMC YUKON 4DR SUV 
 
 Audio/Mobile Video        
 WIRE  COLOR  POLARITY  LOCATION 
 Battery  ORANGE  (+)  RADIO HARNESS 
 Accesory   
   THE RADIO HARNESS DOES NOT PROVIDE A SWITCHED POWER SOURCE. RUN A WIRE TO THE FUSEBOX FOR SWITCHED POWER. THE ACCESSORY TURN-ON AND AMPLIFIER TURN-ON ARE CONTROLLED BY THE CLASS 2 SERIAL NETWORK. 
 Ground  BLACK/ WHITE  (-)  RADIO HARNESS 
 Illumination  BROWN  (+)  RADIO HARNESS 
 Dimmer  GRAY  (+)  RADIO HARNESS 
 LF Speaker (+)  TAN 
 LF Speaker (-)  GRAY 
 RF Speaker (+)  LIGHT GREEN 
 RF Speaker (-)  DARK GREEN 
 LR Speaker (+)  BROWN 
 LR Speaker (-)  YELLOW 
 RR Speaker (+)  DARK BLUE 
 RR Speaker (-)  LIGHT BLUE 
 Steering Cntrls  OPTIONAL 
   THIS VEHICLE MAY BE EQUIPPED WITH OPTIONAL ONSTAR® TELEMATICS EQUIPMENT. USE AN APPROPRIATE INTEGRATION HARNESS OR INSTALLATION PROCEDURE TO ENSURE PROPER FUNCTION OF THIS EQUIPMENT. 
 Speed Cntrl  OPTIONAL 
 Radio Security  YES 
 Security        
 WIRE  COLOR  POLARITY  LOCATION 
 Battery  RED  (+)  IGNITION SWITCH HARNESS 
 Ignition 1  PINK  (+)  IGNITION SWITCH HARNESS 
 Starter 1  YELLOW  (+)  IGNITION SWITCH HARNESS 
 All Door Trigger  GRAY/BLACK  (-)  AT MODULE IN DRIVERS DOOR 
 Convenience        
 WIRE  COLOR  POLARITY  LOCATION 
 LF Pk Lt Bulb  BROWN  (+)  AT FRONT LEFT PARKING LIGHT 
 RF Pk Lt Bulb  BROWN  (+)  AT FRONT RIGHT PARKING LIGHT 
 LR Pk Lt Bulb  BROWN  (+)  AT REAR LEFT PARKING LIGHT 
 RR Pk Lt Bulb  BROWN  (+)  AT REAR RIGHT PARKING LIGHT 
 Remote Start        
 WIRE  COLOR  POLARITY  LOCATION 
 Battery  RED  (+)  IGNITION SWITCH HARNESS 
 Ignition 1  PINK  (+)  IGNITION SWITCH HARNESS 
 Ignition 2  WHITE  (+)  IGNITION SWITCH HARNESS 
 Accessory 1  ORANGE  (+)  IGNITION SWITCH HARNESS 
 Starter 1  YELLOW  (+)  IGNITION SWITCH HARNESS 
 Anti-Theft Type  GM PASSLOCK II® ANTI-THEFT SYSTEM 
 Anti-Theft Descript  THE BCM MODULE MUST SEE A SPECIFIC RESISTANCE VALUE BEFORE THE VEHICLE WILL START PROPERLY 
 Tachometer  WHITE  (-)  AT IGNITION COIL 
 Modules        
 WIRE  LOCATION     
 Please select another category
 Doorlocks/Windows        
 WIRE  COLOR  POLARITY  LOCATION 
 Door Lock Circuit  CLASS 2 DATABUS 
 Power Unlock  MUST USE A GM DATABUS INTERFACE MODULE  DATA  AT SWITCH ON RIGHT REAR ROOF PILLAR IN CARGO AREA 
 PowerLock  LIGHT BLUE  (-)  AT SWITCH ON RIGHT REAR ROOF PILLAR IN CARGO AREA 
 Driver Mtr Unlock  TAN  (REV)  DRIVERS DOOR 
 Driver Mtr Lock  GREY  (REV)  DRIVERS DOOR 
 Pas Mtr Unlock  TAN  (REV)  PASSENGER DOOR 
 Pas Mtr Lock  GREY  (REV)  PASSENGERS DOOR

 thanks for the info i'm looking forward to interfacing the data buss

 recieved info to install remote start /alarm on 05 denali using aps596 and dei 457g interface it mentioed if equipped with on star use and appropiate intergration harness or installation procedure to ensure  proper function, can anyone supply info or steps to be taken to avoid problems with on star

are the windows controlled by the data buss if so is their a interface unit that you would recommend if not can i go to drivers windows switches and diode isolate each and connect all together to be controlled by 2 seperate channels for up & down,also should i use a diode with a rating higher than a 1n4001(prv) how much current will be drawn with all 4 windows operating at the same time or i could do just the front windows

 can someone tell me the wire color for data input @ diagnostic connector on 05 denali that will take single wire output from dei 457gw data bus interface also wire colors for front windows and can they be found @ drivers kick panel

Here is the plug that you need to tap into for the databus wire: The YELLOW square is the spot that you want to tap into for the databus wire.

<"https://www.velocitymotorsport.com/images/install_notes/databus_plug.jpg">

installed aps997 with dei 457gw data buss interface is their a easier way to get the door triggers + or - then having to run a wire to each door and diode isolate,also unclear on the gray/black wire on 457gw for option 1positve dome  light circuit i did not connect it and the interior lights do not come on when the doors are open the 997 allows you to program time delay for dome light so it arms immediately i did not preform that procedure but will completeinstall and can use some advice

the wire on the 457 will bypass the interior light output to the alarm when the remotestarter shuts down. remember...the interior  lights come on when it shuts down....this will cause the alarm to go off ....falsing.

xs

On the 05's there is a gray black wire in the bcm (?) under the steering column in the far right plug that can work for a door trigger. Its actually a domelight wire, but as long as you bypass the door trigger input to the alarm after remote start shut down, it'll work fine.

adding window rollup to aps 997 using dei 530t looking for info on connecting  it do i have to go directly to individual window motors or can i go todrivers window switch