Print Page | Close Window

need 98 corvette alarm diagram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=75878
Printed Date: July 14, 2025 at 11:58 AM


Topic: need 98 corvette alarm diagram

Posted By: mainlyrich
Subject: need 98 corvette alarm diagram
Date Posted: April 08, 2006 at 2:00 AM

I need 98 corvette alarm diagram and bcm pinouts



Replies:

Posted By: 88vette
Date Posted: April 08, 2006 at 10:48 AM

Go to www.bulldogsecurity.com and look under wiring diagrams.

Here is what it says:

CORVETTE 1997 -2001
 
GM's VATS ANTI-THEFT System, Requires 791 Bypass Module
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) IGNITION SWITCH HARNESS  
STARTERYELLOW (+) IGNITION SWITCH HARNESS  
STARTER 2N/A 
IGNITION 1PINK (+)IGNITION SWITCH HARNESS 
IGNITION 2N/A  
IGNITION 3N/A  
ACCESSORY /HEATER BLOWER 1ORANGE (+) IGNITION SWITCH HARNESS  
ACCESSORY /HEATER BLOWER 2N/A  
KEYSENSEN/A  
PARKING LIGHTS ( - )N/A  
PARKING LIGHTS ( + )BROWN (+) @ HEADLIGHT SWITCH  
POWER LOCKRED / BLACK (TYPE B) IN EITHER DOOR HARNESS  
POWER UNLOCKORANGE / BLACK (TYPE B) IN EITHER DOOR HARNESS  
LOCK MOTOR WIREGRAY (+) IN DRIVERS DOOR HARNESS  
DOOR TRIGGERGRAY/BLACK(-) and BLACK/ WHITE(-) Use both, See NOTE *2 @ BCM, See NOTE *4 10585_CORVETTE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISIONGRAY/BLACK (-) @ BCM, See NOTE *4  
TRUNK RELEASELIGHT BLUE (-) @ BCM, See NOTE *4  
SLIDING POWER DOORN/A  
HORNBLACK (-) @ BCM, See NOTE *4  
TACHWHITE @ PCM, See NOTE *3  
WAIT TO START LIGHTN/A  
BRAKEWHITE (+) @ SWITCH ABOVE BRAKE PEDAL  
FACTORY ALARM DISARM LIGHT GREEN (-) INSIDE DRIVERS DOOR  
ANTI-THEFTSee NOTE *1 GM's VATS System @ Ignition Switch  
NOTES
NOTE *1 The VATS (Vehicle Anti Theft System) wire may be (2) thin YELLOW wires, (2)thin TAN wires or (2) thin WHITE wires, these wires are usually in a ORANGE or BLACK HEAT SHRINK TUBE, but at times are left out of the tube and ran by themselves up under the dash to the security module.

NOTE *2 The GRAY/BLACK (-) is for the DRIVERS DOOR and the BLACK/ WHITE (-) is for the PASSENGER DOOR, when connecting to an ALARM SYSTEM, us both wires and DIODE ISOLATE See DIAGRAM

NOTE *3 The PCM (Power Control Module) is located on the PASSENGER SIDE OF THE ENGINE COMPARTMENT. You will need to remove the right front tire and remove access panel in the Inner fender to get to the PCM. The TACH WIRE is located in the BLUE connector Pin 35.

NOTE *4 The BCM (Body Control Module) is located in the PASSENGER FOOTWELL under the CARPET





Posted By: NowYaKnow
Date Posted: April 08, 2006 at 2:06 PM
Here's the pinouts for the 3 connectors at the BCM. I formatted the first one, then got lazy on the other two..

BCM Connector 1: 24 Pin

A1 - Not Used
A2 - Not Used
A3 WHT/BLK - Ignition Key Resistor Feed
A4 ORN - Fuse Output - Type III Fuse
A5 Not Used
A6 Not Used
A7 Not Used
A8 Not Used
A9 BLK/WHT Ground - Clean
A10 Not Used
A11 Not Used
A12 BLU DK - Interior Lamp Relay Output - Coil

B1 Not Used
B2 PPL/WHT Ignition Key Resistor Return
B3 GRY Rear Fog Lamp Relay Control (Export)
B4 DK GRN/WHT Fog Lamp Relay Output - Coil
B5 Not Used
B6 LT GRN Serial Data Signal - Class B - 10400 BAUD - Diagnostic To Body Module
B7 GRY ABSTRNS Relay Control
B8 Not Used
B9 LT BLU Trunk Release Relay Output - Coil
B10 BLK Horn Relay Output - Coil
B11 BRN Fuse Output - Ignition 3 - Type III Fuse
B12 Not Used

BCM Connector 2: 32 Pin

C1
DK BLU
38
Back Up Lamp Relay Feed - Coil

C2
GRY/BLK
745
Door Ajar Switch Signal - LT FRT

C3
WHT
193
RR Defogger Relay Output - Coil

C4
ORN
640
Fuse Output - BATT - Type III Fuse

C5
-
-
Not Used

C6
TAN
159
Key Reminder Switch Output

C7
-
-
Not Used

C8
-
-
Not Used

C9
PNK/BLK
109
Hood Ajar Switch Signal

C10
PPL
681
Rear Defogger Switch Signal - Secondary

C11
-
-
Not Used

C12
RED / BLK
744
Trunk Ajar Switch Signal

C13
-
-
Not Used

C14
LT GRN
80
Key Reminder Switch Signal

C15
LT GRN
1601
Steering Column Lock Signal

C16
-
-
Not Used

D1
BLK/WHT
746
Door Ajar Switch Signal - Right FRT

D2
-
-
Not Used

D3
-
-
Not Used

D4
ORN
192
Fog Lamp Switch Output - FRT

D5
LT BLU
187
Fog Lamp Switch Output - RR

D6
-
-
Not Used

D7
DK BLU
15
Turn Signal Lamp Feed - RT FRT

D8
LT BLU
14
Turn Signal Lamp Feed - LT FRT

D9
BLK
1576
Trunk Release Switch Output

D10
-
-
Not Used

D11
-
-
Not Used

D12
YEL
243
Fuse Output - Accessory - Type III Fuse

D13
PNK
1039
Fuse Output - Ignition 1 - Type III Fuse

D14
-
-
Not Used

D15
BRN/WHT
1571
Traction Control System Switch Signal

D16
ORN
1915
AAS Modulator Feed - LT RR


BCM Connector 3: 16 Pin

A1
-
-
Not Used

A2
BLK
150
Ground

A3
GRY/BLK
690
Courtesy Lamp Relay Output - Coil

A4
ORN
2540
Not Used

A5
-
-
Not Used

A6
PPL
1604
Steering Column Unlock Feed

A7
LT BLU/BLK
1914
AAS Modulator Output - Hold - LT RR

A8
ORN
1603
Steering Column Lock Feed

B1
BRN
1244
I/P Lamp Feed #2

B2
YEL
390
I/P Panel Lamp Feed - Tertiary

B3
-
-
Not Used

B4
YEL
183
Fog Lamp Indicator - FRT

B5
-
-
Not Used

B6
GRY
8
Instrument Panel Lamp Feed

B7
YEL/BLK
625
Vehicle Anti - Theft System Starter Enable Relay Output Coil

B8
TAN
159
Key Reminder Switch Output





Posted By: mainlyrich
Date Posted: April 08, 2006 at 5:24 PM
Thats guys this is exactly what I needed.




Posted By: 88vette
Date Posted: April 08, 2006 at 9:45 PM

Glad to be of help!

posted_image






Print Page | Close Window