2005 Malibu Maxx SKE Light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76268
Printed Date: May 13, 2024 at 8:05 PM

Topic: 2005 Malibu Maxx SKE Light

Posted By: Joe Neal
Subject: 2005 Malibu Maxx SKE Light
Date Posted: April 15, 2006 at 11:31 AM

Installed Omega Alarm with Keyless Entry on 2005 Malibu MAXX, .
Customer says he gets a SKE Display when he Unlocks with Omega Alarm and turns on Ignition.
Any Ideas???
Customer says Alarm works Great, but is worried about ??SKE?? Display???

Thanks

Replies:

Posted By: Joe Neal
Date Posted: April 15, 2006 at 9:35 PM

Has anyone seen this problem??

Posted By: gcorrea
Date Posted: April 16, 2006 at 12:53 AM

i own a 2005 malibu sedan and installed a k9 classic atv in it and havent had any problems. can it possibly be something else? can it have a code set in the bcm?

-------------
gcorrea

Posted By: Joe Neal
Date Posted: April 16, 2006 at 9:31 AM

Customer lives 50 miles away & I am just going by what he has to say.........
Apparently, when he Locks Doors at Door Panel ( I told him not to ) he comes back & Unlocks with Omega Remote. Starts car. He then gets "SKE" on his Dash Display??
Was wondering if it is from Factory Security??

THANKS gcorrea for the Response

-------------
10 Times I did it.......The 1st one was the Best

Posted By: john ogrady
Date Posted: April 16, 2006 at 9:05 PM

A lot of vehicles these days have both a Anti-Theft System and Alarm system from the factory.The alarm is sometimes called Contents alarm or perimeter alarm.These are two different systems.Most aftermarket alarms or remote car starters dis-arm the OEM alarm with a pulse ground signal when the doors are unlocked or when the remote start is activated.Some vehicles need a postive pulse to dis-arm if so use a relay to change.With the Anti-Theft in most cases for the remote start you need a by-pass module.