I have recently purchased an Aftermarket Generation AGA 0801 Keyless Entry system for installation in my 95 s10 pickup (without factory keyless entry, but with power locks).
Having installed a Viper remote start and keyless entry in my Caprice, I thought this would be a breeze. Unfortunately this off brand system provides virtually no documentation which makes it hard.
If anyone can help me make sense of this diagram and give me a step by step of what to connect where, I'll gladly send you a small bonus via paypal once I get this in and working. I've included the entire manual, all two pages of it, including the diagram.
Thanks again!
Manual
Diagram
Your
truck uses a
5-wire door lock interface if it was not equipped with keyless entry from the factory. You would follow figure 3 in your diagram.
Yellow/Black and Yellow/White to +12V fused source
WHITE/ Black to lock motor side
ORANGE / Black to lock switch side
White to unlock motor side
Orange to unlock switch side
Hope this helps
Keep us posted
Find your LOCK & Unlock wires in Vehicle
You need to cut your LOCK & UNLOCK wires in half.
One side of Lock & Unlock wires will show 12 Volts when you press Switch...That is the SWITCH side of cut wires
The other side of cut wires will go to Actuators
ORANGE = Switch Side of LOCK wire
WHITE = Actuator Side of LOCK wire
YELLOW = 12 Volts CONSTANT
ORANGE / Black = Switch Side of UNLOCK wire
WHITE / Black = Actuator Side of UNLOCK wire
YELLOW / Black = 12 Volts CONSTANT
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
WIRING INFORMATION: 1995 Chevy S-10 Pickup
WIRE WIRE COLOR LOCATION
12V CONSTANT WIRE RED Ignition harness
STARTER WIRE PURPLE Ignition harness
12V IGNITION WIRE PINK Ignition harness
SECOND 12V IGNITION WIRE PINK/WHITE Ignition harness
12V ACCESSORY WIRE ORANGE Ignition harness
POWER DOOR LOCK (positive trigger on
vehicles with OEM keyless entry, 5-wire
reverse polarity on vehicles without OEM
keyless entry)
LT.BLUE Harness In Either Kick Panel Or Module
Attached To Under Dash Panel
POWER DOOR UNLOCK (positive trigger on
vehicles with OEM keyless entry, 5-wire
reverse polarity on vehicles without OEM
keyless entry)
WHITE Harness In Either Kick Panel Or Module
Attached To Under Dash Panel
PARKING LIGHTS (+) BROWN At Headlight Switch
DOOR TRIGGER/ DOMELIGHT
SUPERVISION (-)
WHITE or BLACK Under Dash Light Or Module Attached To
Under Dash Panel
TACHOMETER WIRE WHITE Ignition Coil Top Passenger Side Of Engine
BRAKE WIRE (+) WHITE
-------------
dragon
Twelvoltz wrote:
OOPS!
YES, follow MO's Diagram, I read the diagram too quickly and have it wrong!!!
Sorry about that!
You have it right??!!!
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.