Print Page | Close Window

97 Isuzu Rodeo Alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76596
Printed Date: July 18, 2025 at 8:53 AM


Topic: 97 Isuzu Rodeo Alarm

Posted By: metalpres
Subject: 97 Isuzu Rodeo Alarm
Date Posted: April 21, 2006 at 11:25 PM

ok so I am attempting to replace the factory keyless entry/alarm with a new code alarm keyless entry/alarm (the remotes for the old system are missing and a whole new system was cheaper then replacing the remotes) anyway, i am assuming I can just use the wires that connect to the original module under the seat by cutting off the harness, when I disconnect the old system the car wont start however, will the car start again with the new system connected or is this something to do with needing the old one and should I just leave it and install the new on top of the old one? sorry for such a long question couldnt think of a shorter way to word it.



Replies:

Posted By: auex
Date Posted: April 21, 2006 at 11:41 PM
Just leave it and install the new alarm.

97 rodeo

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.


Print Page | Close Window