Remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76681
Printed Date: May 14, 2025 at 1:34 PM
Topic: Remote starter
Posted By: rtron
Subject: Remote starter
Date Posted: April 23, 2006 at 5:08 PM
Hi everybody
I install remote car starter by myself look like I got evrery thing work however the engine start in 30 second and then turn off it keep a few time I'm not sure what problem is if some expert here can help me it would be appreciate
Replies:
Posted By: mo12v
Date Posted: April 23, 2006 at 5:10 PM
Check Tach
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: rtron
Date Posted: April 23, 2006 at 5:13 PM
I'm not quite understand Can you please explain
Thank you
Posted By: mo12v
Date Posted: April 23, 2006 at 7:11 PM
rtron] wrote:
'm not quite understand Can you please explain
Thank you
Most Remote Start require a TACH or Voltage Sense hook-up to detect that the Engine has Started. This detection method will keep the Engine running the required set time. It would also help if you Post:
Year, Make & Model of Vehicle & what you are installing ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: rtron
Date Posted: April 23, 2006 at 11:20 PM
mo12v
Thank you for your input
I'm dong Toyota camry 99 I can't up load my Wiring diagram can I send you an email please?
Posted By: Velocity Motors
Date Posted: April 24, 2006 at 9:33 AM
If it's running for 30 seconds, it's probably not the tach. I sure hope that if the unit thinks that it's over reving it will shut off the car before 30 seconds ! Check to see if your unit has a diagnostics feature that will tell you why the remote starter failed or turned off. I had this problem before in a vehicle and it turned out that the brake wire was giving 12 volts after the car had started running about 20 seconds - 1 minute into the run time.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: rtron
Date Posted: April 24, 2006 at 12:57 PM
can someone show me where the tach is located on a 1999 camry?
Posted By: rtron
Date Posted: April 25, 2006 at 10:06 AM
I check my TACH it's 1000RPM I think it's OK is that right?
Posted By: Velocity Motors
Date Posted: April 25, 2006 at 8:50 PM
The tach wire should read 1-6 volts in AC on your DMM. You can use an injector wire as well for the tach signal if you want.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|