2005 Dodge Ram, door locks, 997 Prestige?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76759
Printed Date: May 13, 2025 at 3:52 PM

Topic: 2005 Dodge Ram, door locks, 997 Prestige?

Posted By: crystandslowjam
Subject: 2005 Dodge Ram, door locks, 997 Prestige?
Date Posted: April 25, 2006 at 2:21 AM

I'm installing a 997 Prestige 2-way. I've seen you guys mention the resistors and but I sill failed to follow you about the wiring configuration. I've read the locks are negative and must use relays. Can someone guide me on wiring up the relays. I'm also having a similar problem with the parking lights... Any help would be greatly appreciated.

Replies:

Posted By: Twelvoltz
Date Posted: April 25, 2006 at 7:18 AM

If you take a look at this document under type H it will give you a diagram of how to hook up your door locks the manual is written for DEI products so ignore the colors listed for lock and unlock triggers. Just apply the negative outputs from your APS997 to trigger the relays.

Your parking lights use a similar setup, but your APS997 has an internal relay for parking lights, you would hook your RED / white (parking light supply) to ground and the white (parking light output) with a 560ohm resistor inline to the truck's parking light wire (WHITE/ light green at switch).

Hope this helps

Posted By: crystandslowjam
Date Posted: April 28, 2006 at 1:06 AM

Thanks Twelvoltz that diagram was exactly what I needed. I was actually in aw when they all locked and unlocked. I still get a chill hittin the remote.