I've got a Clifford Matrix 3 3-channel alarm with 4-button remote. The only additional feature besides the lights flashing that I'm using is the remote door lock/unlock. What output wire do I need to use to activate the solenoid for my shaved doors? I need an output with a switched ground. I've got approximately 6 free wires that I can use: a RED / white, BLACK/ white, purple, and blue wire from the 12-pin plug, and a RED / white and BLACK/ white wire from the 8-pin plug. Like I said, I need to know which of these wires will provide a ground when the button on my remote is pushed. Also, which channel should I be looking for?
Dan
-------------
1948 Chevrolet Fleetline - rat rod
1998 Dodge Dakota full custom
2007 Chevrolet Silverado 2500HD - wife's daily
2008 Dodge Caliber SXT - 'cause 30mpg don't suck!
ch 2 is RED / white on 12 pin harness the RED / white in the 8 pin is used with this wire, it control the input ot the on board relay.
ch 3 is the WHITE/ blue on the 12 pin harness this wire will control a relay.
the others wires u list are for hood and door triggers etc etc.
i upload the clifford matrix 3 install guide, its in the downlaod section
Thanks for the help. I'll see if I can't get it to work when I get home tonight.
Dan
-------------
1948 Chevrolet Fleetline - rat rod
1998 Dodge Dakota full custom
2007 Chevrolet Silverado 2500HD - wife's daily
2008 Dodge Caliber SXT - 'cause 30mpg don't suck!