Print Page | Close Window

old 551T install manual

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76863
Printed Date: May 14, 2025 at 1:52 AM


Topic: old 551T install manual

Posted By: wiretapper
Subject: old 551T install manual
Date Posted: April 26, 2006 at 11:01 PM

Can anyone supply me with the install manual or at least the tach programming procedure on the old Valet 551T?    I started doing remote starters with 552's and they look completely different. The old standard "start it up and push the valet button" came after the 551T I guess.

Thanks in advance.




Replies:

Posted By: Twelvoltz
Date Posted: April 27, 2006 at 6:36 AM
Th551T installation manual has been added to the downloads section, you can find it here.




Posted By: wiretapper
Date Posted: April 27, 2006 at 8:36 AM

Thanks but it's still not the same.

I guess this unit is the first generation. It's got to be at least 10 yrs old. Works fine, but it's occasionally starting to grind the starter AFTER it's been running for approx 30 seconds-1 minute. I was attempting to reprogram the tach reference, and noticed it's older than any of the maunals I have. Gotta be at least circa '95.




Posted By: swamprat323
Date Posted: April 27, 2006 at 12:51 PM
maybe the relay is gettign stuck



Posted By: wiretapper
Date Posted: April 27, 2006 at 2:27 PM

swamprat323 wrote:
maybe the relay is gettign stuck

I'm going to go through all of that today, but I wanted to reprogram the tach reference as a precaution. Why I'm not pushing this guy for a new one, I have no idea.

This unit doesn't even have a port for a program button, but has dip switches inside. I can't seem to track down the programming instructions for something this old. Sucks, because everything else works fine. Even the master unit, an old Automate 3 is still working fine.


Print Page | Close Window