1994 Honda Accord + Valet 561R

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76902
Printed Date: May 10, 2025 at 4:49 AM

Topic: 1994 Honda Accord + Valet 561R

Posted By: michael88
Subject: 1994 Honda Accord + Valet 561R
Date Posted: April 27, 2006 at 5:11 PM

Hi, I plan on installing the Valet 561R Remote start/keyless entry system on a 1994 Honda Accord LX AT. Though I like to think of myself as the amateur mechanic (T-Belts/H2o pump, clutches, brakes, etc.)...I've never installed electronics on a car other than a plug and play head unit.

I have the wiring diagram and a Craftsman digital multimeter, is the Craftsman adequate?
What else is needed?
Is there a specific type/brand of wire strippers/cutters recommended?
What kind of connection do I use to join wires? Is soldering required?
Also, does a 1994 Accord require the DEI Bypass Module?

Any tips (besides take it to a pro posted_image

) or info is appreciated.

Replies:

Posted By: 05gt
Date Posted: April 27, 2006 at 7:13 PM

Craftsman multimeter will do just fine

no specific type or brand of wire strippers just make sure they are sharp

always solder your connections and then tape, don't use T-Taps or anything else

no it doesn't need any bypass modules

Posted By: michael88
Date Posted: April 27, 2006 at 9:51 PM

Thanks for the info O5gt.

What is the best method to tap into a wire and make a connection?

Posted By: Twelvoltz
Date Posted: April 28, 2006 at 10:36 AM

This thread will explain it all for you.

Posted By: michael88
Date Posted: April 28, 2006 at 11:09 PM

Thanks, Twelvoltz. That did clear up how to not only make a connection, but a great one.