door lock that dont lock

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=78529
Printed Date: May 17, 2024 at 5:25 PM

Topic: door lock that dont lock

Posted By: catrisha
Subject: door lock that dont lock
Date Posted: May 31, 2006 at 3:26 PM

Hello!

I have a 96 mitsubishi galant and install a keyless entry (from ebay). The problem is my right door! It works before I install the remote system, now it dont lock like the others. Im wondering if its electrical or mechanical? What should I do?

Replies:

Posted By: KarTuneMan
Date Posted: May 31, 2006 at 11:02 PM

Have you "unhooked" the keyless to see if it works without it? What did you "hook" too?

Lock is GRN/WHT NEG(-) drivers kick

Unlock is RED / GRN NEG(-) smae location.....

-------------

Posted By: catrisha
Date Posted: June 01, 2006 at 2:49 PM

Thanks for the tip KarTune Man. I tried your suggestion today. I remove the keyless connection and put back the original central locking of the car. To make the problem worst, the right door lock work sometimes and sometimes dont.

Posted By: bmwpwner
Date Posted: June 03, 2006 at 12:49 AM

take that switch and clean the contacts on the inside of the switch. also, after mitsu switches get older you can add relays to take the pressure off the switch rather than buy a new switch. good luck and hope this helps.

-------------
"I cannot teach anybody anything, I can only make them think."
-Socrates-

Posted By: mad550
Date Posted: June 03, 2006 at 7:57 AM

The next best option is to replace the factory locking motor with a generic motor and it should work fine with your factory module.

-------------
WOW Sight and Sound
Maroochydore
Nothing is impossible!
Do it right the first time or don't do it at all.

Posted By: catrisha
Date Posted: June 03, 2006 at 3:52 PM

Thanks for the tips guys! Im sure this will solve my problem.

Print Page | Close Window